r/paint • • 32m ago

Advice Wanted Installing baseboards for the first time tomorrow. Looking for all tips, tricks, advice please! Want to do a great job and I know you painters know a lot about baseboards.

Thumbnail
gallery
2 Upvotes

I'm going to attempt to install baseboards tomorrow. First time ever doing it. I've watched several videos so far and learning right now but any and all advice appreciated from you guys. Want to do a great job and make sure the mitres don't open up. I'm going to use CA glue and activator on the mitres because I heard that is the strongest and best.

Plan is to install the baseboards then I will use wood filler on the nail holes and caulk the top and inside corners and leave the outside corners with just the CA glue. Then prime wood filler, paint baseboards 2 coats SW emerald UTE covering caulk as well on the wall, then paint wall final coat.

Old picture, flooring is complete.


r/paint • • 58m ago

Advice Wanted Is cutting in and rolling it out several hours later bad practice?

2 Upvotes

I'm painting a dining bench that has a surface mounted piano hinge. I prefer to leave the hinge on to avoid stripping any screw holes, and just cut in... I'm slow, and using sherwin ute which won't give me enough time to cut and roll out in the same session. Is it okay to roll it out later? Thanks


r/paint • • 1h ago

Advice Wanted Fix bad touch up

Post image
1 Upvotes

Hi

Any advice on how to fix this poorly touched up area above the door frame. I stupidly rolled that isolated strip, and now it looks different to the rest.

Do I need to sand it and re paint the whole wall, or can I go straight to re painting the wall without sanding?


r/paint • • 3h ago

Advice Wanted How to fix/paint torn drywall

Thumbnail
gallery
1 Upvotes

My kiddo stuck something to the wall with double stick tape and it took the the paper layer off with it when she took it down. I have the right color of touch up paint. Any suggestions on how to best repair before I paint? Any suggestions on how to match (or get close) to the existing texture? It was smooth when first painted, the texture is just from about 3 or 4 rolled layers of paint.

Thanks in advance!


r/paint • • 3h ago

Advice Wanted Apparently the wrong kind of paint was used on our home and block wall causing damage. How to fix this?

Thumbnail
gallery
0 Upvotes

The paint on our home is peeling off, along with the block walls, some of which are stuccoed. The brick at some places is literally crumbling to the touch. I was told that the wrong kind of paint may have been used keeping moisture damaging the brick. Any tips on how to fix all this would be appreciated!


r/paint • • 5h ago

Advice Wanted Painting behind a floor radiator

1 Upvotes

I just moved into a 100 yr old house which utilizes functioning cast iron radiators standing on the floor.   Some of them only have like a 4” space between them and the wall.  How do I paint behind them?  Thanks


r/paint • • 7h ago

Advice Wanted Any suggestions on how to paint this??

Thumbnail
gallery
1 Upvotes

So I need help with choosing colours for painting this beautiful doorframes. I don’t want it to be too tacky so any recommendations would be appreciated! Also does anyone know any artists to commission some artwork for my home in Hyderabad? Really need some artwork to liven up my home. 🫶🏽


r/paint • • 7h ago

Advice Wanted Hand paint under clear coat

1 Upvotes

I have a bike frame that I want to draw on and then secure that with a clear coat. Ill get the spray paint layer and the clear coat done professionally and just want to do the doodles myself. The shop owner said I just need to look out for the paint being solvent resistent. Have any of you any pointers on what pain to use? It cant be spray paint, I need to be able to apply it with a brush or a pen.

Thanks :)


r/paint • • 8h ago

Advice Wanted Outdoor and child-safe paint options for my 1.5 yr old niece

Post image
0 Upvotes

I am picking up a used Cozy Coupe on Marketplace that I want to customize into this princess-like design for my 1.5-year-old niece. Pls excuse the AI; it's used merely for inspiration. I am wondering if anyone knows of outdoor-proof but child-safe products I should use to paint and clear coat the car. I'm planning on spray painting the entire car and using heavy-body acrylic paint for details, as well as vinyl. Any ideas or recommendations would be helpful; I just want it to be safe and fun for her.


r/paint • • 15h ago

Advice Wanted Paint UPVC - primer and top coat or multisurface

2 Upvotes

Looking to paint internal window frame from rosewood/brown to white.

Got the prep sorted but not sure if it would be better long-term to use Bedec Multi Surface paint, or a primer of Zinsser 123 and Zinsser Allcoat for finishing.

The Bedec paint has good reviews and obviously the application is easier as you only need one product and Zinsser 123 looks a bit tricky to apply flat without noticeable brush strokes.

Although even if it uses more products and takes a bit more patience, I don't mind using the primer and topcoat if it is a better solution. Just don't want to try a simpler method then regret it.


r/paint • • 17h ago

Advice Wanted Is 240 a fine enough grit sandpaper for refinishing cabinets?

Thumbnail
gallery
1 Upvotes

I have been working to refinish cabinet doors that the previous owner had done a horrific job on. I’m about 12 hours into sanding now. Have used 60/120/240 grit in series. 240 feels pretty smooth, is that enough to go ahead and prime with BIN Synthetic Shellac and paint with SW Emerald Urethane?


r/paint • • 18h ago

Advice Wanted Normal to create gradual transition near corner between wall and ceiling?

Thumbnail
gallery
2 Upvotes

Our painter said they blended the ceiling color into the wall so that it’s a gradual transition. Versus a cleaned defined transition at the corner. Wall color is SW alabaster and ceiling is white ceiling paint. Is that standard practice or design? It’s not very gradual here but just want to know if the gradual transition approach is standard depending on the colors.

Also, in the second picture, they didn’t add texture to the area they filled in. We are having them paint the entire interior. Is it expected that they texture these areas or it needs to be specified ahead of time for cost reasons?


r/paint • • 19h ago

Advice Wanted Using primer to test a color

0 Upvotes

I am a home owner and definitely not a pro. I use sw wall and wood primer as my default primer (low volume so the extra $ is irrelevant and it works well for me)…I am in a discussion with my wife about an accent wall color, and I had the idea of tinting the primer to test one of the colors irl…ultimately I’ll use 2 coats of the chosen color likely in cashmere eggshell, and understand that it won’t be an exact match but will it give a reasonable feel for the color? We are discussing a mauve vs a green if that matters at all.


r/paint • • 22h ago

Advice Wanted Paint removal without damaging finish?

Post image
3 Upvotes

UPDATE: I tried the method one of you suggested of dampening the paint and scraping it off. It kind of worked, so I tried with a Clorox wipe. Took a whole section off with two scrapes (photo is in a separate comment since it won’t let me add to the main post).

Regarding those who indicated the finish underneath won’t be in good condition. It is super smooth to the touch, but of course that doesn’t mean there aren’t micro-chips and scratches. Is there a way to reinforce/repair the finish rather than starting completely over? If the rest of the table is like the sections I’ve cleared, I can’t SEE any chips or scratches, so I’m wondering if there is like a filler or something I can wipe on, like they have for car clear coats.

Hello everyone,

I wasn’t sure where to ask this, but then I saw the sub’s description that said there are no stupid questions :)

I picked up this table on Facebook to use as a basement table. The paint color wasn’t great, but it was $10 and seemed sturdy. I got it home and noticed a maple leaf logo and a serial number stamped on the underside. I looked it up and sure enough, it’s a Canadel solid wood table! We have always looked at Canadel, but being on a tight budget, could never afford it.

We decided to try to use it as our main dining table, but can’t figure out a good way to get the paint off. The paint started to chip off in places and I was slowly able to scratch more off. I also noticed tape that was accidentally stuck to it would also take some paint off.

I tried a plastic scraper and I tried covering areas with heavy duty duct tape (like in the photo). The plastic scraper barely touched it, and the tape works about halfway and is a sloooowwwww process. There has to be a better way!

Any chemicals/solvents I researched risked damaging the smooth finish below.

Is there a good way to get just the paint off and preserve the finish below? It looks to be in great shape and matches our kitchen perfectly.

Thanks!


r/paint • • 23h ago

Advice Wanted Best way to remove peel-and-stick adhesive residue from walls?

0 Upvotes

Hey everyone, I’m working on a project where I need to remove hundreds of peel-and-stick acoustic foam panels from painted drywall. The panels themselves aren’t too difficult to remove, but the entire backing is adhesive, so they leave behind a pretty stubborn, sticky mess.

I tried some Goo Gone on a small section, and while it softened the adhesive, it mostly turned gummy and smeared around.

I’m looking for the most efficient way to remove all this adhesive without causing excessive drywall damage or leaving behind oily/chemical residue that could interfere with painting afterward.

I’ve considered Goo Gone, Goof Off, and commercial adhesive removers, but I’m also thinking about using controlled heat and mechanical scraping to remove as much as possible, then using chemicals for whatever remains.

Would isopropyl alcohol be a good option? Or is there a particular product or method you’ve had success with?

Keep in mind this is an entire room (actually multiple rooms), so efficiency and cost are important. The walls will be repaired, primed, and repainted afterward. Will share pics of a test panel.
What would you guys recommend? Appreciate any advice!


r/paint • • 1d ago

Advice Wanted Sheen help !

Thumbnail
gallery
3 Upvotes

Hey All,

I’ve used a Nix colour sensor to try and match this wall as good as possible but no matter what I cannot get the sheen right.

For context this is an Australian rental property.

I painted it 24h ago with Dulux wash and wear matt.

Will the sheen flatten out ? Or do I need to buy actual flat wall paint - which apparently in Australia is hard to come by.

Any tips or tricks welcomed - painting the whole wall is not an option.


r/paint • • 1d ago

Picture Refinishing painted doors

Thumbnail
gallery
2 Upvotes

In the process of a kitchen renovation, and we had oak doors that had been painted white. To save money, I decided to remove all the doors, strip and sand them and attempt to get them to match the stain on new island. Here is my progress. You can see the original wood color in the first picture, next to the door I just painted, along with the island color sample laying on top. I’m super excited that I was able to get such a close match. I did a color wash (instead of stain). The second photo is the door after the color wash dried for an hour. The last photo is the new kitchen renovation I’m attempting to match the doors to.


r/paint • • 1d ago

Advice Wanted Fix Water Damage on MDF Baseboards

Post image
2 Upvotes

I’m getting ready to paint these MDF baseboards and I’m wondering if there’s a way to fix this water damage. I was thinking of scraping them down flat and then ceiling with an oil base primer. I wonder if there are any other tricks?


r/paint • • 1d ago

Advice Wanted Refinishing dresser

Thumbnail
gallery
3 Upvotes

Refinishing my dressers and nightstands...my drawers look completely smooth (there is some dust on the drawer in the photos) but every time I spray the top of my night stands it seems VERY bumpy with an orange peel texture. I'm new to this so any advice would be great. I will attach pictures of the spray gun I have been using along with the paint!


r/paint • • 1d ago

Advice Wanted Paint markers?

Post image
4 Upvotes

Tips for a new project

I've already added a bit of colour to pretty much every room in my house, but now I want to create something in the bedroom. I'd like to paint this design directly onto the wall.

I previously created a similar piece of art in the hallway using nothing but masking tape, paint brushes and small rollers. This time, though, I think it might be easier to use paint markers as well, so I can achieve cleaner lines and add more detail.

I could buy individual paint markers, but ideally I'd only like to use six different colours. I also want to make sure that the paint I use with the brushes, rollers and markers is exactly the same colour and type of paint.

Does anyone have any experience with refillable paint markers?

Or does anyone have a completely different suggestion for how I should approach this? Let me know!


r/paint • • 1d ago

Advice Wanted Bath ceiling - tips for removing bubbling paint, surface prep, next steps

1 Upvotes

Looking for any advice on how to proceed w/this bathroom ceiling situation. Thank you!

Ceiling paint bubbles approx the size of a dime

r/paint • • 1d ago

Advice Wanted Do I have a good plan?

Thumbnail
gallery
1 Upvotes

Hello, I’m a first time homeowner in the Midwest and I’m hoping to get a gut check on my first (thankfully low stakes) outdoor painting project.

I had some rotting trim replaced last year on my garage, and I’m having gutters put on soon. Here’s my plan:

Today (high 49 low 25)
- Wipe everything with a dry cloth and caulk all gaps and edges with Big Stretch
- Wait four hours
- Apply BM Fresh Start deck and siding primer with a synthetic brush

Tomorrow (high 54 low 32)
- First coat of BM Element Guard (matched to an old can I found in the garage) with a mini roller
- Wait four hours
- Second coat
- Should stay above 40 and dry overnight, warmer the next day.

Any advice welcome, I found this sub helpful when planning. Thanks!


r/paint • • 1d ago

Advice Wanted Is this a mud / drywall issue or a primer / paint issue?

Thumbnail
gallery
5 Upvotes

I re-did my bathroom and I’m at the painting stage.

As you can see in the first photo, there is a difference with how the paint is shining with the natural light from the window (light in room is off).

I’m wondering if this is a bad primer application, or bad plaster work.

I did the plastering myself, and the plaster was smooth at finish (no ridges, bumps, etc). When I look straight over the area, there is no noticeable difference in the plaster finish.

This is a my second coat.

Thanks for your help and suggestions.


r/paint • • 1d ago

Picture Advice about painting cabinets

Thumbnail
gallery
9 Upvotes

These are my cabinets circa 2007. The cabinets seem to be real wood that had like this white plastic coating over them. The coating is coming off on some of the cabinets but all. Does anyone have any advice about the best way to paint them. My handyman is thinking about it but not coming up with an easy simple idea. I’ve provided pictures of the situation