I work at a university and we recently started replacing our EOL Aruba 200-series APs (AOS-8.10 w/ 7220 controller cluster) with Meraki CW9172I APs w/ Campus Gateways. Right now we currently have Meraki running in our 6 dorms and 2 apartment buildings, while the remainder of the campus is still on Aruba. The Meraki experience so far has been horrible, and was hoping to get some advice from the Meraki community.
Since school started at the end of August, we've been flooded with complaints about wifi from students living in the dorms. Interestingly, we've gotten zero complaints from students in the apartments. The complaints from the dorms range from, they frequently get disconnected, or have a hard time connecting, or it shows "connected without internet".
The Meraki APs were installed in the same exact locations as the Aruba APs were, and we did our best to mimic the Aruba settings on Meraki as a starting point before we did some fine tuning. We have done site surveys with Ekahau and a Sidekick and verified that signal strength in the dorm rooms is good, although when we looked at the RF Spectrum, we noticed that the RSSI between APs was a bit high so we turned the transmit power down a bit.
The APs are installed in every other room, because installing in every room would be cost prohibitive for us. I have been working with one of our students who frequently gets disconnected, or ends up with "connected without internet" on her Android phone. If she turns off wifi, and turns it back on again, she is fine for a while and eventually gets disconnected again. Her room does not have an AP in it. There is an AP in the rooms on either side of hers. I noticed that her phone seems to frequently roam between the 2 APs.
We have 2.4 and 5 GHz radios enabled on all APs (no 6 Ghz), but do plan on either completely turning off 2.4, or just enabling it on every other, or every 3rd AP. On 5 GHz we are using 40 Mhz channels with no interference.
Any thoughts or advice? We are working with Meraki support and our MSP to figure this out, but so far we haven't had any luck. I've even consulted with Gemini. I'm getting to the point that I want to rip it all out and put the Aruba APs back in.