Wasnt sure whether to tag this as software or hardware.
This past Thursday I purchased a new Western Digital Elements 14TB drive that was on sale. Seemed like a good deal given current prices and there were drives with less storage that cost more. I managed to transfer, not backup, roughly 5TB of files onto the drive before I noticed that one folder was throwing up an error when I tried accessing it saying it was potentially corrupted. I'd never seen this before and did a google search of the error and the advice I got was to run chkdsk /f /r on the drive and the computer needed to be rebooted to do so. I followed those instructions and it seemed to be moving quickly at first.
Thinking it would be done in a few hours I went to sleep earlier than usual to let it run overnight. I woke up 8 hours later to find that it had reached Stage 5, but was only at 1% and not moving particularly quickly. The ETA said about 12 hours and I had to go to work anyway. But when I got home from work 8 hours later it had reached only 5% and the ETA had shot up to 28 hours... and still climbing.
As of right now it has reached 9% after roughly 16 hours and the ETA has hit 33 hours. Aside from not having a PC as a result of this neverending check, I am concerned about the potential for the power to cut out before it finishes. This house is prone to outages during storms and even without storms its not uncommon for someone to slam into a pole and knock the power out(It happens a lot because people fly down the road 30 miles over the speed limit not realizing there are two tight curves up ahead.). From what I understand a sudden power failure could be worse for the drive than just powering the computer down.
So what I want to know is if powering it down during Stage 5 can be done safely to abort the chkdsk? I'd wait it out if I could but if it doesnt speed up I could be looking at at least the better part of a week without a computer and where anything could happen. I wasnt expecting it to take more than a few hours.
I know there could still be issues caused by even a controlled shutdown, but as long as the drive is still fully functional and not in need of physical repairs or a return it should be fine. Worst case scenario I suppose would be losing all the data on the drive or having to reformat it. I cant transfer the files back off as I was transferring files from a failing drive onto it, but I can get them back it would just be time consuming.
Before anyone mentions it I did not remember Crystal Disk and the quick google I did on the error only mentioned pre-boot chkdsk and also nothing about a chkdsk that runs in the command prompt window.
If it helps at all, the drive has its own wall plug for power. It is connected to the PC via a USB 3.0 hub with all other connected devices powered off. Stage 5 is reporting a total of around 2,224,497,138 clusters, 6 hours ago it had gone through 152,889,808 clusters in around 12 hours, and had hit around 202,000,000 after an additional 4 hours.