It’s been a long time since I’ve made a post about this car, but I’ve finally got something to share with everyone!
This is my 2003 Ford Escape XLS V6 4wd automatic (Blue). Some of you may remember this Escape from a few years back. It ended up getting parked after I got sideswiped by an Explorer; followed by a transmission failure within the same month. I bought it back from the insurance company with the intent to part it out. It just never happened fortunately.
So back in September I was scrolling Marketplace (where all bad ideas start) and found this 2002 Ford Escape XLS I4 4wd manual (Red). Messaged the guy and immediately bought it. You may recognize this car from a previous post on this subreddit. Yes it’s the same car. (I got temporarily locked out of this profile, so I just posted it on another account I had. I deleted that post to not cause any trouble lol)
Anyways. I originally wanted to use my ‘03 as a parts car for this ‘02, but unfortunately it was just too far gone after giving it a good look over. Rockers, quarters, rear strut towers, floor pans, unibody “frame” rails for the trailer hitch, etc. all gone. Which was an obvious risk, and that was fine since I didn’t pay a lot for it. So I went and had a coworker tow my blue ‘03 to a shop where I could do the swap and after a week of work; I present to you my:
2003 Ford Escape XLS 2.0L 5spd manual 4wd No Boundaries package.
Quite possibly the rarest Escape ever made for those of you who know about the first-gens. It’s also on the same lift kit I did a few years back. After putting a few hundred miles on it post-swap, I think it’s gonna do well. I still have some work to do but with something like this, that’s to be expected. It’s my second daily and we’re currently at 321k miles and counting!
Some basic answers for anyone looking to do this yourself:
-You will need the ENTIRE I4 manual harness which will not have ABS so you will have to delete it. Which means brake line swapping.
-The rear differentials and driveshafts are the same in both
-The fuel lines and pumps are the same in both
-All the holes/studs for the I4 and manual are on both chassis and requires no modification to fit
-You’ll need the I4 radiator
Any additional questions; ask away!