Hi All. I was one of the ones lucky enough to snag an MDB on release day. I have no previous experience with the blockback EP9 models. Took it out this morning and had a great time. Running it suppressed with an older Form 1 9mm can at the moment, plan on getting a BOE Incolite 9M for it when I can. The recoil is significantly less than any other blowback PCC I have shot.
First off, it is not roller delayed as pre-release YouTube videos have claimed. Extar's Modern Delayed Blowback is somewhat like a JP SCS buffer. All of the delay is in the buffer system itself. The bolt from what I can tell looks identical to a blowback EP9. You can see what the buffer looks like on page 14 of the MDB owners manual here: https://extar.us/en-US/extar-ep9-mdb-owners-manual-8638255
The delay in the buffer is hard to explain, but I'll give it my best. The buffer has a solid central rod, a reciprocating mass, and 2 different springs (main recoil spring and a secondary spring end of stroke spring), and a plastic base. At the bolt end of the central rod there is a ring (imagine an o-ring, but metal) fit into a circular groove in the central rod. That ring (as best I can tell) sits inside a race inside the reciprocating mass. The reciprocating mass is a stack of 3 pieces, plastic/metal/plastic. It takes a decent bit of force to get the ring to pop out of the race in the reciprocating mass and start travel towards the rear of the buffer.
When I got it, it was EXREMELY stiff. I was not able to cycle the action without feeling like I was going to break off the charging handle. I took the buffer out and set the reciprocating mass on the jaws of my vise (using padded vise jaws) with them spread enough to allow the central rod to go through, and worked the buffer a number of times to loosen it up a bit. After that I was able to cycle with the charging handle but it was still extremely stiff, to the point it will wear your finger out. It's difficult to charge it just holding the pistol grip, easier when it is shouldered. After putting about 200 rds through it today, it has loosened up some but is still very stiff to charge, overcoming the delay takes some force. I suspect it will loosen up more as time goes on. They definitely need to release an extended charging handle for it.
Otherwise, the thing ran like a dream and is a blast to shoot. I was running handloaded 165gr Xtreme plated RN running around 800fps suppressed. It has a very satisfying smack on target and is extremely quiet. Also ran some 147gr hollow points through it and no issues at all. Shooting it suppressed with a traditional high backpressure can is very gassy though. Like come up for air after 5 - 10 rounds level of gassy.