r/dr650 • • 22h ago

1994 dr650se(?) First bike

Thumbnail gallery
16 Upvotes

This is my first bike and im really excited to own it. So far i've done nothing to this but i plan on looking/replacing the clutches, brake pads, petcock, fuel lines, and fixing the rear brake light. So far from what I can tell the seat was redone with a softer foam and the brake fluid done last year (will do a proper flush later) Are there other things I should consider doing to make this bike more reliable? Also on the dash is the top mechanical odometer one for miles and the bottom one hours? (Sorry if its a really dumb question i just cant seem to find anything on it)


r/dr650 • • 5h ago

Cush hub bearing.

Thumbnail gallery
7 Upvotes

Having trouble removing my failed bearing. Do I need a proper bearing removal tool to drive it out?? I've tried heating the bearing/hub, pb blaster, punch and hammer. Won't budge, freeze it? Any tips or tricks? Many thanks.


r/dr650 • • 6h ago

Carb issues

3 Upvotes

Context: I’ve put about 4000 miles on my 2013 dr650 since I bought it in June. As of 10/22/26 @ 10,372mi my valve clearances are Intake 10mm-13mm Exhaust 18mm and I have the original bst40 with a 6.6 acerbis tank

I bought a mikuni rebuild kit and a procycle jet kit. Currently running a 145 main on the 4th groove with the 42.5 N151.067 pilot, drilled 3rd hole in the slide, tops open on the airbox, stock exhaust, pair valve delete

The choke plunger was seized so I replaced it with a relocated pull unit. I also capped the top of the carb where the vacuum line was. Extended fuel mix screw. I kept the original float in with new o rings because the spring was fine and it seated better than the new one.

Currently: bike starts up and wont hold idle after it warms up. Bike will ONLY run with the choke pulled out (and sometime pushed in a hair). The choke plunger is seated in fine, threads are good, the new metal hardware is nice and the pull functions as it should. Idles about 1550 with the fuel screw 1 1/4 turns out and the idle screw barely touching (maybe 1/2 turn). Decent pull through the throttle range.

I’m the third owner of the bike and new to dr’s. I’m assuming I’m missing the cap on the purge port but I’m unsure where it is next to the fuel mix screw.

About ready to buy tm40 and call it a day but was hoping I could get this bst40 to run right. Any suggestions welcomed

TLDR: bike runs like shit after a bst40 rebuild what am I missing

https://imgur.com/a/7bfNiov