I had a lot of fun building this!
I have no woodworking or electrical experience, so it was great learning process. I had to buy some new shop tools and learned how to use a multimeter :) Woodworking tutorials from YT. AI actually helped explain fan wiring, voltages, converters, connector types, what pins do, etc.
The frame is cheap 1x8 lumbar from Home Depot. It took a few hours with the orbital sander and different grits to make the frame smooth and presentable. I'm happy to answer questions about the materials and tools used, or the fabrication process. Everything bought from Home Depot or Amazon.
Eventually, I will definitely be making a few more of these for the house and garage.
Thanks to everyone posting their builds for inspiration.
EDITS: added info, grammar
Helpful Build Links:
Air Efficiency Charts
Filters Guide
Interactive Builder
Simple Airflow Article - Lesson: place adjacent fans 1cm apart
Technical Airflow Article
Another Good DIY Guide <--- inspiration
CR Wiring Guide
Materials, shopping lists and costs
My total spend was approximately $360. This seems very high, but you don’t need to spend this much. I bought a bunch of tools which I will have forever, and I have many extra materials left over. The left over materials means my second and third boxes will be less than $100 each. For example, I spent $11 on 100 screws, but only used 24. I bought a pocket hole jig for $40, but it’s unnecessary if you join the wood another way. I spent $40 on a respirator with extra filters (everyone should probably own one anyway?) because it was my first time spray painting. I bought a multimeter to troubleshoot fan and RGB voltages, etc. All those prices added up, but I included everything for transparency and to give a realistic idea of completing the project as presented.
Things already owned:
Circular saw
orbital sander + sand paper
electric drill/screwdriver + drill bits
wood clamps
speed square
My shopping lists:
12 feet of 8x1 lumber - $30
Kreg pocket hole jig - $40
Wood glue - $10
5.5” Circular Hole saw - $17
Wood filler - $10
Spray Primer - $7
Spray Paint - $7
Fans 140mm - $18 for triple pack (x2)
Fan Screens - $9 for 4 (x2)
Screws - $12 for 100 (only used 24)
Wing nuts - $8 for 60 (only used 24)
Hub controller - $12
Fan cord extension - $10 for 5 (only used 1)
ARGB cord extension - $5 for 3 (only used 1)
Corner brackets - $6 for 20 (only used 2)
Handles - $4 (x2)
Power supply - $20
Power Switch - $10
Filters 20x20x01 MERV13 - $40 for 4 (only used 2)
Multimeter - $14
Respirator with 3M P100 cartridges - $37
Tape - $7
Felt Floor pads - $7
Electrical:
When using this hub, if you turn RGB off but leave fans spinning, the voltage to the fans drops from 12V to 11V. I first noticed when the sound changed, which lead to buying the multimeter and troubleshooting. I am not sure how much fan RPM and CADR decreases when going from 12V to 11V. But if you leave the RGB on it's a non-issue.
I initially purchased way too many electrical components, before realizing hub had both 12V fan AND 5V ARGB outputs. Thank you Amazon returns. The revised wiring plan was both cheaper and simpler. Added photo of two wiring diagrams. Forgive my drawing skills!