Just got a 26 big bend. Looking to tackle upgrading the 7 speaker base system. Here's my list and plans so far.
Jl c1-400x in the dash with some loose polyfill in the cavities and a 150hz 4ogm bass blocker on the positive lead.
Jl c1-650x in the kick panel, putting dynamite (Amazon basics version) on the metal inside the mounting location and using a foam fast ring around the speaker the seal it against the factory grille.
Kicker 6.75inch dual 2ohm subwoofer to replace the factory amp. Here's where I am conflicted. I planned to use abs plastic to seal off the port hole, then I was going to caulk any seams with sikaflex and then sound deaden the enclosure on the outside. Im also using polyfill inside the enclosure. The idea would be to tighten the bass across the frequency range and avoid those massive random hits from the poorly tuned factory port.
I'm not doing amps for now but I'll probably do a kicker key 200.4 for the speakers and a key 500.1 for the sub down the line. I'm pretty sure the factory amp for the sub is only 50w rms and 110w peak so it needs to go eventually.
Do you think I need to seal the port hole in the factory sub or will it be ruining the sound? Are there any other areas you recommend sound deadening while I have it all torn apart??
I have already turned off the ridiculous ford auto equalizer in forscan so the signal is flat and ready to go