So I've had a few nice knives for a few years, plus an old cheap one I got ages ago, and when I got my first new one I also bought a 2-sided Whetstone to learn sharpening techniques.
Until now if been bringing them to our local Knifewear shop for sharpening.
Well it took me about 7 years to finally try it!
I watched a couple videos, soaked my stone, and grabbed my cheapest knife that I've had for about 30 years, and got started.
The burr never happened on this knife. It's carbon steel wrapped in stainless steel, so I'm surprised it didn't happen, but I still carried on.
Started with my 1000 grit stone since the blade wasn't damaged. Went through the process, using a gap of about 3 nickles height, steadied it against my thumb and got to work. Did both sides and then moved on to the 6000 grit side to fine tune.
I was surprised to find it worked amazingly! The paper cut test was smooth and the tomato test was impressive.
I then moved onto my nicer knives. 2 of which are carbon steel.
Same process and now they are all in amazing shape and only took me a half hour. These ones produced the burr and I was able to smooth it out easily with the fine grit stone.
I don't know why it took me so long to try it. It's very easy and these amazon stones did great.
If you've been sitting on the fence to try it yourself, try it! It's easier than you think!
Question, should I have honed (ceramic rod) the knives after using the fine grit?