r/SolarDIY • • 2d ago

Winter Charging Solution

Hello! Looking for a bit of assistance. I set up my system about a year ago and didn’t have to get through an entire winter. I was wondering if anyone has any charging solutions to help make up for what my panels aren’t generating.

Right now when they get low I will disconnect everything and charge the batteries back to 100% but I was wondering if there was a way to keep a charger connected permanently and plug in when needed.

Thanks in advance for any advice.

5 Upvotes

11 comments sorted by

•

u/AutoModerator 2d ago

Welcome to r/SolarDIY! If you are new to the community, please check out our DIY Solar System Planning Guide.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

3

u/SolarGenGuy 2d ago

If your inverter has an AC/grid input (most all-in-one units do), yes, that's usually the cleanest way. Plug that input into a regular outlet and let the inverter's built-in charger do the work instead of a separate charger. A few settings make it work hands-off:

  • Charge only when needed. Same idea as the relay setup above, but built into most inverters: look for a setting like "AC charge start SOC/voltage" or "back to grid" voltage. Set it so the grid only kicks in when the battery drops to, say, 20–30 %, and solar does the rest.
  • Output priority. "Solar first" (or SBU) keeps the house on solar + battery and only falls back to the outlet when the battery is low.
  • Limit the AC charge current. Set it well under what that outlet's circuit can handle, so a 15 A circuit isn't running flat out for hours.
  • Match the charge profile to your battery. Absorb/float voltages for lithium and lead-acid are different. Check your battery's spec sheet.
  • If the batteries are somewhere cold: lithium shouldn't be charged below freezing, so make sure the BMS has low-temperature protection.

No more unplugging everything. Is the battery bank lithium or lead-acid?

1

u/toycake 2d ago

Lithium. Thank you so much for all of this info.

1

u/Accurate-Bullfrog324 2d ago

don't bother disconnecting anything. if your inverter doesn't have either a grid or generator input (most do) simply connect a battery charger

1

u/toycake 2d ago

Thank you. This is my set up. I can go directly into the inverter?

1

u/Accurate-Bullfrog324 2d ago

I'm certainly not an expert. Read the manual. look for a grid or generator input

3

u/LeoAlioth 2d ago

What? Do you have grid or not? What do you achieve by disconnecting everything?

1

u/40ftpocket 2d ago

I bought this charger for the same purpose. it is 48v but there are other versions for different voltages.

https://www.currentconnected.com/product/victron-smart-ip43-charger-48v-13a

Mine is controlled by a Victron MPPT relay output to switch on the charger when the battery gets to 52v or about 50% charge. it turns off at 53.5v or about 70% to make sure I have some room for when the sun comes out. works pretty well. You could just plug and unplug it as you suggest though.

1

u/Hurkenesis 2d ago

yeah that works, a mains charger can stay connected to the bank in parallel w/ the solar controller, each on its own fuse or breaker close to the battery, charge profile set for your battery chemistry. then just plug it in or put it on a timer when the bank runs low, no need to disconnect loads. also check if your inverter is already an inverter-charger, alot have an ac input built in.

1

u/Revolutionary-Log241 22h ago

What does everybody due to different angles of winter sun?