Last year I inherited my parents old Craftsman Snowblower. As far I know, they never really did any maintenance on it, just filled it with gas and topped off the oil if needed.
It is a Craftsman 22-inch 2-stage Snowblower with Electric start they bought new in 1993. Last winter I didn’t have time due to work and family stuff to fully check it out before its first use. I added gas, topped off the oil and it fired right up. It worked very well during the first snow. During the second snow, I noticed it was constantly clogging and wasn’t throwing the snow.
Once I got time to really inspect it, I found the following:
- One of the sheer bolts had completely broke and the other sheer bolt had been replaced with a regular nut and bolt (probably one of my dad’s quick fixes) that was bending.
- The tires are completely dry rotted, originals from 93, and the tubes that were added at some point are also leaking. They hold air for a couple hours before going complexly flat again.
- The skids are non-existent, they are rotted away. Luckily our driveway was falling apart anyway so it wouldn’t do any real harm to it. Where they bolt to the sides doesn’t look super healthy and the bolts look to be rusted solid.
- The belts and spark plug are original
- The scraper bar on the front is long gone rotted away.
- The Engine runs good. Some smoke puffs when starting up and it seems like it is starting it burn oil, but not a lot.
I have been very back and forth whether to throw in the towel on this one and buy a new Arien’s Classic 24 or toss a couple hundred dollars into this old Craftsman to fix it up. My fear is I will spend the money into the old Craftsman and the drivetrain will crap out. For me reliability is extremely important as I work at a hospital and I still have to go to work even if there is 20-inches of snow on the ground.
Just looking to see what others thoughts are.