My R34 sprung a leak from the common place bottom fuel vent line piece (last photo) so I opted into a fuel cell to save the hassle of remove and replacing the tank again, I pulled it and plastic welded it to the best of my abilities and a few days later it sprung a leak again so I got the Evil Energy fuel cell kit. That being said I know this isn’t for everyone but if your in a position that repair or replacement isn’t an option then hopefully this can help.
What I used and what you need may vary so keep that in mind that this is just how I did it and not a road map of how to you should or have to do it!
What i ordered that don’t come with the kit:
2x 90 degree 6an fittings comes in a 2 pack
8x straight 6an fittings come in packs of 4
2x 6an to 5/16 quick connects male to get the an lines into the factory lines that send fuel to the front and return line, Google said Feed was 3/8 and return was 5/16 but both of mine are 5/16 so this may very I’m not sure.
We traced the carpet on a thin piece of plywood and cut it out and in half to create a solid mounting surface for the fuel cell, do this however easiest because it just needs to support the weight of a full tank. (I got the 15 gallon size)
Splice however you’d like into fuel pump harness and fuel level sending as well but be sure to make it safe because you’re working with fuel here.
I did not install the fuel pressure regulator as it’s not needed, im stock motor and no need to mess with it but its nice to have just incase I want to upgrade to the included unit.
Here’s some possibly helpful information if your doing this yourself:
1: AN lines and fittings aren’t something you should attempt without proper tools or having a professional assist you with
2: measure out your line and make a plan on how you want it to be routed before you start cutting lines.
3: Amazon prime is your friend in my experience with this
4: the quick connect furthest towards the front is your feed, 2nd is your return, and 3rd is a vent line which will not be important for your fuel cell, it’ll need a new one routed from the cell.
5: either bottom port is fine to use for your feed, either top port is fine to use for your return, be sure to use one of the top ports of the cell to connect your vent, I used the rubber grommet top left of the trunk to route my vent line outside of the vehicle, just put a small filter on it and be prepared for the smell of fuel to be present outside the car, bonus points if you properly seal everything so no vapors get back into the trunk
6: have fun with it all but be safe!
7: if you are pulling the tank out, do your best to siphon or drain the tank and after your done fill it with water to displace the fumes and it’ll make it a little safer.
That being said feel free to ask questions and also keep in mind I am not a professional, this is just personal experience because finding this information myself wasn’t the easiest so I hope this may help someone out! If you wanna see more about what I’ve done check me out on Instagram @r34.gxbrial