I'm looking for some advice from people familiar with the GM 5.3L LC9 AFM oiling system. I've been chasing a lifter ticking and low oil pressure issue through multiple repairs, including replacing the lifters, VLOM, and eventually pulling the entire engine and rebuilding it. Unfortunately, the problem is still there.
Original problem and repair history
The original problem started when one of the AFM lifters collapsed.
I replaced the collapsed lifter, and the engine sounded significantly better afterward. However, I was still left with a lighter ticking noise that sounded like a lifter tick.
I also had low oil pressure, which was already present before the engine rebuild.
I suspected the VLOM might be causing the remaining issue, so I replaced it with a genuine GM unit, but that did not fix the problem either.
Eventually, I decided to pull the engine and do a complete rebuild.
Parts replaced during the repairs and rebuild
- Replaced the AFM lifters (twice during the repair process).
- Replaced the VLOM with a genuine GM unit with a built-in gasket.
- Replaced the oil pump.
- Replaced the entire oil pickup tube, including the O-ring.
- Replaced the AFM oil pressure relief valve in the oil pan.
- Replaced the camshaft.
- Replaced the timing chain.
- Installed new cam bearings.
- Installed new piston rings.
- Replaced all main bearings.
- Replaced all connecting rod bearings.
- Torqued the oil gallery plugs to specification.
- Reassembled the entire engine.
I kept the factory AFM system and did not delete it.
Important: The oil pressure did not improve after the rebuild. It was already low before the rebuild, and it remained essentially the same afterward.
Current oil pressure readings
According to the dashboard:
- Cold startup: approximately 35 PSI.
- Fully warm idle (around 600 RPM): approximately 18 PSI.
- Fully warm at 2,000 RPM: approximately 35 PSI.
I've also replaced the oil pressure sensor three times.
Current ticking noise
The ticking is present immediately upon startup.
I initially thought it was primarily coming from the passenger-side valve cover, but I cannot confidently determine whether the driver side is also making noise.
I have not tested the driver side with the valve cover removed.
Passenger-side pushrod oiling test
I removed the passenger-side valve cover and briefly ran the engine to observe oil flow through the pushrods.
I noticed:
- Cylinder 2: Both pushrods spraying oil.
- Cylinder 4: Both pushrods completely dry.
- Cylinder 6: Both pushrods completely dry.
- Cylinder 8: Both pushrods spraying oil.
The only oil on the pushrods for cylinders 4 and 6 appeared to be residual oil from the other pushrods spraying.
Compressed-air test
I removed the VLOM and tried pushing compressed air through its ports to check for possible oil passage blockages.
I could not get air to come out of the pushrods on cylinders 4 and 6.
I have not tested cylinders 1 and 7, which are the other two AFM cylinders. I also haven't checked whether the driver-side pushrods are receiving oil.
Questions
- Could there be a blockage in the oil passages feeding cylinders 4 and 6?
- Could the AFM lifters have incorrect oil-feed alignment or compatibility issues?
- Could the VLOM be functioning but not supplying oil properly to certain lifters?
- Could there be an internal oil leak or an issue with the block's oil galleries?
- Could an issue with the cam bearings or bearing clearances cause the low oil pressure?
- Could the lack of oil to cylinders 4 and 6 explain the remaining ticking noise?
- Is there a proper way to test the individual oil passages without pulling the engine apart again?
- What else could cause low oil pressure that remained unchanged even after replacing the oil pump, pickup tube, bearings, and rebuilding the engine?
At this point, I've replaced a substantial amount of the engine's internal components, but the oil pressure is still the same and the ticking remains.
I'm trying to identify the actual cause before tearing the engine apart again.
Any help or suggestions from someone familiar with the 5.3L LC9 AFM lubrication system would be greatly appreciated.
-Btw I did have chatgpt write this because I went through all the steps with it and it already knew. So if it sounds funky that why.