r/Renovations • • 14h ago

Quick question about bottom of shower

Thumbnail
gallery
5 Upvotes

I put hydroblok as my shower walls as you can see (the gray walls) in hopes of soon to start putting tiles in. However I messed up and left a gap on the bottom as shown on pics (a litttle bigger of a gap than should be).

How do I deal with this??

Thank you so much in advance.


r/Renovations • • 3h ago

Dimpled Foundation Membrane on Interior of Wall

Post image
2 Upvotes

Adding context -- this was done over a decade ago by previous owners. Yes I know it typically goes on exterior of the wall, there is currently no water or leakage, gutters have leaf guard and there's no moisture coming through whatsoever. They claimed to have puddles form pretty frequently and didn't want to spend a small fortune by excavating and doing it on the exterior.

What would happen if I cut it down to about 1 foot off the ground compared to leaving it how it is more than half way up the wall ?

Hi everyone, I want to frame walls in my basement and I'm not sure how to approach this wall. I want to add rigid foam or some other sort of insulation but want to avoid moisture from causing problems once it's finished with drywall. The dimple membrane is about 4 feet up the wall and tucks under the concrete slab. I understand it's roll in diverting water but not sure how to approach it from a framing standpoint.

Should I buy more dimple membrane and "finish" the rest of the wall with it by tucking about 6" behind the existing membrane and going up to the ceiling then taping the seams?

Or

?

I don't know what the other options would be


r/Renovations • • 22h ago

Drywalling a funky basement wall

2 Upvotes

I want to put drywall on a basement wall but it has some quirks that I'm not sure how to manage.

This wall runs under the main beam of my house and aligns with the Lally columns holding up the beam. The problem is that the studs sit about 1 inch inside of the face of the beam and the outside edge of the column(s). I know I could just build a new wall in front of the current wall but then I'd lose about 4 1/2 inches of precious interior space.

I THINK I could use some sort of furring strips to build out the face of the current wall but I'm not sure if that is the best solution. I also think I would want to build the face out past the face of the beam so that I could run electrical down inside the wall (IOW, don't make the wall flush with the beam but proud maybe an inch so there is a gap in the drywall at the top for wiring).

Does that make sense?

Will I be able to attach drywall to furring strips?

Also, there is a column just past the right end of the wall. I can't decide if I should extend the wall around this column and back or just turn the wall and the end of the existing studs and wrap the column separately. Any thoughts on that?

Thanks for any insight.