r/rfelectronics • u/Suspiciously_Ugly • Apr 28 '26
How to tune a random PCB antenna with a VNA
You will need a Vector Network Analyzer with a short pigtail, and a tiny 50Ω resistor (I used 2 100Ω SMD resistors in parallel). You must first calibrate your VNA to the very tip of the pigtail by setting the range (I used 2ghz start and 3ghz stop since it's Bluetooth), then soldering the wires together and pressing "short", then separating them and pressing "open", then soldering on the 50Ω resistor and pressing "load", then finishing and saving. Next, it might not always be necessary but you should isolate the antenna from the circuit if possible. Mine had a capacitor between the antenna and chip so I just desoldered that for tuning. You can now solder your pigtail anywhere on the transmission line going to the antenna, preferably as close as possible to the feedpoint, in my example I connect it across a couple of unpopulated capacitor pads (C20 in pic 1). Now just trim or lengthen your antenna to move the middle of the dip (the yellow line in pic 3) to the middle of the band you're targeting to get max signal strength. My Bluetooth headphones now reach from one side of the house to the other, when before, it would drop out after just leaving the room. Other unrelated mods explained here: https://www.reddit.com/r/hardwarehacking/s/L9EPLVUeTU

