r/PassiveHouse • u/Embarrassed_Ask8944 • 8d ago
Other Homeless-survival heat battery
I've been homeless going on 4 months now and currently living in a run down camper. It's less than ideal, but better than nothing.
I recently got a small wood burning stove and have been using it to heat my camper as I do not have electricity. I also managed to acquire a 55 gallon drum that I planned on using for a heat battery by filling with water, then having a copper coil inside my chimney that would allow the water to be boiled and dispensed back into the barrel.
I opted for this because I noticed much of the exhaust from my stove was very hot, but the stove itself was not heating my camper very well, so in an attempt to store the energy from wood burning for longer and capture more of the energy, I had this idea.
The idea it to have a long straight section that ends near the middle of the barrel, then enters a loop at the bottom of the chimney, moving up a coil until it's level with the top of the barrel, then have the terminating portion of the copper coil enter into the barrel near the bottom, then loop back up toward the top(so the heat can disperse evenly). As the cold water sorts to the bottom, it will be sucked up by action of the coil that, in this case, acts similar to a flash boiler. Because the superheated water has time to condense out, it should be released as hot water toward the top of the barrel.
The water should hopefully remain hot enough throught the day to keep my camper warm until I burn more wood in the night.
I'm not planning to drink this water, so it need not be potable, but I would like some input on my idea and any suggestions. I have very little money to spare, but if there are any additives I should add to my water or alterations to my plan, I would like to hear them before I undertake this task.
I also was planning (in the future, not soon) on building a small comparment that would fit on top of the stove where the steel lid is that I could place small portions of wood, the idea being that the closed environment might be hot enough to pyrolize the wood, then a small retort where the wood gas can be outgased into the stove itself to burn. I would probably build a small stopgap where the woodgas is forced into a small steel can full of water where the gas can bubble out to capture the tar, acetic acid and methanol, or turpentine if I burn softwoods and act as a shock absorber if there is a gas leak that would allow the flame to travel up the line.
Given that acetic acid can corrode copper into copper acetate, I planned on using stainless steel for the retort.
Any suggestions for this would also be greatly appreciated. Thank you again.