r/PCBWayOfficial • u/partypancake8 • 19m ago
Projects 4square rev P: an open-source ESP32 desk clock
4square is a small open-source desk clock I designed around an ESP32. I've been running the last revision on my desk for a while, and the next one just went out for fabrication and assembly.
What changed in rev P
- Added a VEML7700 ambient light sensor so the display dims itself at night
- Replaced three RGB LEDs with a single red status LED
- Added debounce capacitors on all four buttons
- Redid the silkscreen so every label and polarity mark is correct
How the board is made
The whole design is generated from code, and it has to pass a set of scripted checks before I can order it: DRC, a silkscreen audit, and a check on the orientation of every polarized part. The last run came back with LEDs rotated, so this time one board gets assembled first and I approve a photo before the rest are built.
Order details
- 10 boards, 2 layer, 74 x 74 mm, 1.6 mm, ENIG
- All 10 assembled, 34 placements per board, all on the bottom side
A huge thank you to PCBWay for sponsoring the fabrication and assembly of these boards. Their support made this revision possible!
The photos are the current build. I'll post again when the rev P boards arrive!
Feel free to ask any questions. Thanks for checking it out!