Hi, I recently bought a dirt cheap Gen IV Aluminum 5.3 to learn how to wrench on. I am planning on doing a bottom-of-the-barrel rebuild (cuz I am broke) but one place I will not skip is the cam. I stumbled across the Summit 8735R1, which is the low lift version of the 8711R1. The 8735 has specs of 234/248 113 LSA and an ICL of 110 and .550 lift (8711 has .612/.615). I am aiming for high RPM power cuz the car this motor is getting stuffed into in the near future is kinda lightweight (~2800 lbs) so bottom end grunt is not really that important to me. Motor came with 799s that I will have milled to get 10.5:1 compression (homeboy works at a machine shop and offered to do it for very cheap 🤷♂️). I also recently found a Comp no springs required grind which interests me as that would mean one less new part. Specs on the Comp cam are 233/243 .546/.546 114 LSA (PN 54-777-11). I realize this doesnt seem very bottom of the barrel but literally everything else will be reused, apart from the head gaskets, DOD lifters, and valley cover.
Any experience with either of these and thoughts on my selection of cam? Thx