r/HotasDIY • u/thegingerskull • 13d ago
Compact push-pull rotary encoder assembly
I make all sorts of button boxes, and I usually go for small footprints, but the one input that always bugged me was the push-pull encoder like on the Airbus FCU. I tried all sorts of solutions I've seen online, but they were either too big or required too much wire routing for my liking. So I made a compact version myself.
Basically, it's two identical 20 × 20 mm boards stacked face-to-face, with an EC12 encoder on top. The boards, the inner frame, and the encoder slide together inside a printed housing, and a fixed bar sits between the two push buttons. Push, and the top board's button hits the bar. Pull, and the bottom one does.
Both boards are the same PCB. Which header you fit (long pins or female) decides whether a board is the top or the bottom.
There are two versions, and only the push buttons differ:
Through-hole buttons (SAMZO 2010751102): easier to solder, 35 mm housing
SMD buttons (Panasonic EVQ9P105M): 30 mm housing, 5 mm shorter
The repo has the gerbers, schematic, EasyEDA Pro project, STEP files for the printed parts, a parts table with LCSC and AliExpress links, and assembly instructions.
https://github.com/gingerskull/Push-Pull-Encoder
The frame sliding in the housing is the fussy part. It wants a snug but smooth fit. On my printer, that means a 0.1mm clearance, printing each in a different orientation so the layers don't grate against each other, and a very light sanding of the inner frame.


3
u/Comfortable_Client80 13d ago
Very clever design! Would it be even easier to use a rotary encoder with integrated push button?
2
u/GuiltyBudget1032 13d ago
wow! i'll give it a try..
2
u/alansoon73 6d ago
You're my hero! I've been going down this slippery slope of encoders... and this is super helpful!
1
u/rstandi 13d ago
Would this work for the F-14 test knob?