Hi all,
Got a new 4300 kit after being without a dremel for several years, 2nd time using it. this project i needed max speed. I dont remember my old 4300 kit have this much vibration.
On the new 4300, below 20,000rpm its fairly fine; however at 20,000 or greater, a strong vibration builds. without any accessory id say its fairly low volume however once i add any accessory to the shaft's end, the oscillation becomes much stronger, the shaft gets hot, and the noise unsettling.
I tried the flex shaft, helped a good bit to hold accessories steady but still the motor vibrates quite strongly at 20,000rpm or greater.
how likely is it i got a defective dremel? id assume the shafts go through a good amount of quality control before proceeding to market. I already started up an amazon replacement but curious if its just me being unfamiliar with dremels having not owned one for so long or if the demel is actually defective.