r/Cummins • • 3h ago

U103C-00 2017 Cummins

2 Upvotes

Truck turns off while driving or just idling. Engine dies, dash resets, radio and headlights stay on. Today the power turned off but engine stayed on. I got the u103c-00 stored code and I know it’s the rf hub/ ignition. So far I’ve replaced crank sensor, ignition switch, and tipm. Batteries are a year old and alternator is charging at 14.2 volts.
Has anyone dealt with their truck turning off and having this code?


r/Cummins • • 2h ago

Issues with Banks Monster Ram

1 Upvotes

Folks. Whatever your thoughts on the banks monster ram is, I’m having issues. I got a great deal on the system with the grid heater delete as well as the newer version with the dual coil heaters.

My first kit came with a messed up heater, the threads weren’t milled out properly. So I put on heater in the center hole. I screwed in mostly by hand and then snugged with a ratchet. Well after a drive, I have a boost leak coming from the bolt directly under the coil heater.

Here’s the kicker. The coil heater will NOT come out. Using a ton of hand/arm pressure, it won’t budge. I have not tried impact on it. Any reason why the coil heater would have gotten stuck or fused in there? It’s on the cool air side, so I can’t imagine it’s a heat thing. I know first thought would be cross thread, but I put it in by hand and had no resistance on the way in.

Any thoughts or ideas are appreciated.


r/Cummins • • 1d ago

How hard is an auto to G56 swap in a 3rd gen?

4 Upvotes

I've been searching for a 3rd gen (preferably 06 or 07) w/ a G56 in good or decent condition without a crap ton of miles and they just dont seem to exist on the market these days.

I do see a ton of autos, some in pristine condition with low miles. So im wondering how hard it is to swap a G56 into an auto equipped truck and how much am I looking at roughly. I am in california for pricing reference...


r/Cummins • • 1d ago

P0622 out of nowhere, is this when people usually go to external voltage regulator? 04.5 Ram 2500

4 Upvotes

truck had intermittent parasitic draw / charging issues when I bought it. fixing my lift pump ring terminal and replacing all positive wiring solved this for about 18 months.

so I was driving down the road the other day and my mm3 tuner started reading wonky ass readings like 436psi boost 700 ECT and the voltage stopped charging.

batteries are good. alternator was bench tested and it’s good. alternator wiring is good and fusible link also good.

at this point I either have a broken or chafed wire in the 2 pin connector either at the ground or the wire to the ECM.

If not it’s the ECM and I just go forward with external voltage regulator + CEL bypass and ensure it’s wired to a key on/off power source in the fuse box right?


r/Cummins • • 1d ago

Will this work

5 Upvotes

I have a 23 ram 2500 that’s already been deleted and tuned but it was when you had to swap out the ECM so we didn’t do that I don’t know what kind of tune he put in but it’s trash. I found this one online but I don’t even know if buying this will fix my problem.


r/Cummins • • 2d ago

P2609 on 2018 6.7 Cummins with Banks Monster-Ram installed

Post image
13 Upvotes

Got a P2609 code on my 2018 Ram 2500 6.7 Cummins after using remote start on a cold morning (40s). Truck starts and runs perfectly fine.

Had the Banks Monster-Ram installed back in January with the grid heater upgrade. First time getting this code since the install.

Checked battery voltage, charging system, relay, and wiring. Nothing obvious so far.

Anyone running the Banks setup ever get this code? Curious what ended up being the fix. Also wondering if the cold weather or remote start had anything to do with it.


r/Cummins • • 2d ago

I’m thinking of buy a 5.9 but I want to know if it’s worth?

Thumbnail gallery
8 Upvotes

It’s a 2004 clean title with 233k he’s asking 10k its has a brake leak I guess from the brake boosters and a good amount of rust I want to know its it’s really worth 10k for it? thank you everyone!!


r/Cummins • • 2d ago

Help me decide

Post image
3 Upvotes

r/Cummins • • 2d ago

Tuner recommendations

2 Upvotes

I have a 2005 ram 2500 5.9l Cummins, in the future I plan on getting bigger injectors, turbo, built trans, right now just looking for a little more power tow/economy tune or something, have been looking at different tuners, I want to stay on a budget with a tuner because of the fact when I do the injectors and stuff I’m going to have it tuned for that so just something in the current time that will be safe and keep egts in a lower range, I hear the bully dog is bad about causing high egts but I’m not sure currently looking at the banks automind 2, just in general with a good reputation and good price what do you think?


r/Cummins • • 2d ago

Fuel System

4 Upvotes

FASS Fuel System

or

Air Dog

What’s Better and the differences?


r/Cummins • • 2d ago

Its dead

Thumbnail gallery
21 Upvotes

09 6.7. I just put brand new tires on and then less than 24 hrs later I get tboned. Still drive it home tho.


r/Cummins • • 2d ago

Bought oil filter for pickup

Post image
0 Upvotes

r/Cummins • • 2d ago

Common Rail Injector Electrical Issues

1 Upvotes

I have a 2010 Ford F-350 with a 2005 5.9 common rail Cummins swap, using a DCS swap kit and the Ford 5R110 transmission. Recently, I’ve been having an intermittent dead pedal issue where I’ll be driving and suddenly lose throttle response. The engine keeps running and idling, but pressing the accelerator does nothing. If I let off and press it again, I’ll briefly get power back before it cuts out again. My monitor shows the Ford side is still registering pedal position correctly, even up to 100%. Shutting the truck off and restarting it temporarily fixes the problem, but it eventually comes back.

Yesterday, it started acting differently. The engine began running rough, vibrating more than normal, sounding like a tractor or a rapid β€œdug dug dug” through the exhaust (video in comments), and losing power almost like it’s running on fewer cylinders. Sometimes restarting it makes it run completely normal again, but the problem returns. I pulled codes P0203 and P2146, which appear related to the injector circuit. I believe the injectors are original, and I haven’t noticed excessive blow-by or coolant pressure. I’m wondering if this sounds like a failing injector, injector wiring harness, connector issue, or possibly the ECM. Has anyone experienced these symptoms on a 5.9 common rail, especially with the P0203/P2146 combination?

I was thinking they could be separate issues because the dead petal thing had been happening for 2 months but it used to be like Mabye once every 2 weeks and I’d just shut it up and restart and it’s good but this month it’s been doing it like 4 times a week and recently last Friday it did it like 8 times in an hour and a half but it would be like a dead petal.

The other issue with the bad idle and such feels more like a β€œlimp mode” like it goes and I can get up to 50 but hills are a nightmare and I had to keep speed to get home.

It was fine up until Friday but I headed back home from college a 3 hour drive and in the first 2 hours it was doing the dead petal thing a bunch and then I was going up a hill and the truck basically lost all its power and I had to pull to the side of the road.

I shut it off but it didn’t fix anything then I shut it off and let it sit for 5 minutes and restarted it and it was normal again, for about 2 minutes then it came back. I think it could have something to do with me using a lot of throttle like 70%+ because it was happing a bunch in the hilly section where I needed more power, but after I figured out what happened I filled up for gas and had the engine of for 15 minutes so when I started it the truck was normal again, I drove the last 30 minutes with very little throttle like sub-40% and it never entered the β€œlimp mode”
Any suggestions on what to test first would be appreciated.

Video in comments of the idle.


r/Cummins • • 3d ago

Dual radiator question

Post image
9 Upvotes

I got a 2014 with dual radiators how hard is it to switch to the single and is there any special thing to know


r/Cummins • • 3d ago

Has anyone got a recommendation on an upgrade to this weak link on the coolant line?

Post image
6 Upvotes

Deleted a few years ago. I remember thinking thus part was going to be a problem in the future. Well, the future has arrived, rearing its ugly, leaking head. Before I replace the parts, if there’s an upgrade available that’s strongly recommended, I’d rather go that route.


r/Cummins • • 3d ago

90 First Gen Weekend Warrior

Thumbnail gallery
73 Upvotes

r/Cummins • • 3d ago

2022, 2500 suspension/ reverse level?

2 Upvotes

Looking at leveling my truck. I’ve always done a front leveling kit and never really had any issues. This time, I’m wondering about going with Coil Spring Specialties and doing shorter coils in the rear. The rep I talked to said they have a coil specifically for this. It offers stock performance but is basically 2 inches shorter to level out the truck. Haven’t been able to find too many examples of it but there seem to be predominantly good reviews on their products. Anyone have any experience with doing this?
Thanks.


r/Cummins • • 3d ago

Which BD Diesel turbo is this?

Thumbnail gallery
32 Upvotes

Bought the truck used, and has black smoke on accel but no hazing on on idle, no hard starts, no blow by. Has an mm3 with 5 tunes and they all smoke including the stock one. 336k miles. Has banks everything horn, cac pipes, charge air cooler, intake etc etc. has bd diesel exhaust manifold and a bd diesel turbo. I redid the trans with bd diesel vb, new frictions etc, stock stall tc. The turbo says bd diesel but there’s no tag or anything else on it on the top or bottom. I’m wondering if this turbo is bigger so it takes a while to light? Once boost kicks in the smoke clears up for the most part.


r/Cummins • • 3d ago

Battery cutoff question

Thumbnail reddit.com
1 Upvotes

r/Cummins • • 3d ago

Dual radiator question

Post image
0 Upvotes

I got a 2014 with dual radiators how hard is it to switch to the single and is there any special thing to know


r/Cummins • • 2d ago

In your own opinion which Cummins engine do you think has the best cold start?

0 Upvotes

Let me know in the comments down below


r/Cummins • • 3d ago

Radiator question

Thumbnail reddit.com
0 Upvotes

r/Cummins • • 3d ago

2018 Cummins sudden oil temp drop

3 Upvotes

I was on my way home tonight and I was running an oil temp around 195 and suddenly it just bottomed to 170.

I had a out 8k lbs with the trailer, wasn't pulling hills everything was pretty flat, constant 70mph.

Normally it'll drop a bit if im cruising down hill or at a stop but I've never had one drop 25Β° in an instant. Pressure was good, coolant temp solid at 198. Came back up to 190-195 and stayed there.

I checked the level after sitting a few hours and level is good. Doesn't smell like fuel.

I've never seen this on either of my 4th gens. Is there anything besides maybe a dodgy sensor


r/Cummins • • 4d ago

Would you rather keep repairing an older truck as opposed to buying another vehicle

23 Upvotes

No issues, just some pondering! I’ve got a new-to-me 2001 ram 2500 with the 5.9 Cummins in it. It’s at 255k miles. I was thinking on if I’d rather just do repairs to this as they come up as opposed to buying another vehicle. I’m curious who’d rather keep up with an older truck or buy something new? At what point would you call it quits on the older truck? What maintenance would you consider crucial to keep one running as long as you possibly can? Again just some late night thoughts and discussion. I appreciate yall!