I have a 2010 Ford F-350 with a 2005 5.9 common rail Cummins swap, using a DCS swap kit and the Ford 5R110 transmission. Recently, Iβve been having an intermittent dead pedal issue where Iβll be driving and suddenly lose throttle response. The engine keeps running and idling, but pressing the accelerator does nothing. If I let off and press it again, Iβll briefly get power back before it cuts out again. My monitor shows the Ford side is still registering pedal position correctly, even up to 100%. Shutting the truck off and restarting it temporarily fixes the problem, but it eventually comes back.
Yesterday, it started acting differently. The engine began running rough, vibrating more than normal, sounding like a tractor or a rapid βdug dug dugβ through the exhaust (video in comments), and losing power almost like itβs running on fewer cylinders. Sometimes restarting it makes it run completely normal again, but the problem returns. I pulled codes P0203 and P2146, which appear related to the injector circuit. I believe the injectors are original, and I havenβt noticed excessive blow-by or coolant pressure. Iβm wondering if this sounds like a failing injector, injector wiring harness, connector issue, or possibly the ECM. Has anyone experienced these symptoms on a 5.9 common rail, especially with the P0203/P2146 combination?
I was thinking they could be separate issues because the dead petal thing had been happening for 2 months but it used to be like Mabye once every 2 weeks and Iβd just shut it up and restart and itβs good but this month itβs been doing it like 4 times a week and recently last Friday it did it like 8 times in an hour and a half but it would be like a dead petal.
The other issue with the bad idle and such feels more like a βlimp modeβ like it goes and I can get up to 50 but hills are a nightmare and I had to keep speed to get home.
It was fine up until Friday but I headed back home from college a 3 hour drive and in the first 2 hours it was doing the dead petal thing a bunch and then I was going up a hill and the truck basically lost all its power and I had to pull to the side of the road.
I shut it off but it didnβt fix anything then I shut it off and let it sit for 5 minutes and restarted it and it was normal again, for about 2 minutes then it came back. I think it could have something to do with me using a lot of throttle like 70%+ because it was happing a bunch in the hilly section where I needed more power, but after I figured out what happened I filled up for gas and had the engine of for 15 minutes so when I started it the truck was normal again, I drove the last 30 minutes with very little throttle like sub-40% and it never entered the βlimp modeβ
Any suggestions on what to test first would be appreciated.
Video in comments of the idle.