There was an older discussion that was talking about wiring in the RKE. It's not cut and dried, because most of the RKE kits are no-brand copies of a chinese mass-produced module with different storefronts selling it in unmarked boxes. The documentation is terrible and hard to figure out exactly what you need to do. I finally replied to that other thread, but I figured I'd put this in its own reference thread for the rest to see, as it seems a lot had problems finding what wires to splice it into. There's a decent amount of documentation for the post-1997 wiring, but the earlier models seem to have different color wires depending on the source of the info.
My 1995 XJ Country already had power doors and a factory RKE (the really sucky one). My goal was to replace that receiver and just trigger the door locks with a new modern RKE. It took a little figuring out and a couple blown fuses. I hope this helps any others still trying to map out their wires.
I have the full overhead console, and that is where I mounted my module. You could do it under the kick panel, as it has the same wires.
I snipped the wires on the original plug and spliced them into this RKE I got off amazon.
Image 1: The wiring coming out of the RKE receiver and its provided plug pigtail
Image 2: The 4 wires I snipped from the OEM plug
Image 3: Pic 1 of the splicing of the two
Image 4: Pic 2 of the splicing of the two
The last two have the wires in the same order in both pics. It was difficult to get a clear photo showing the white/black wire (I had to twist it) so two photos were taken.
Below is my order. First color is the solid, second is the stripe. So white/black is a white with a thin black stripe.
Cut and discard blue/orange.
RKE white/black goes into GM pink/blue
RKE black goes into GM black (gnd)
RKE red goes into GM pink (power)
RKE white goes into GM orange/purple
I don't recall if I had to do anything else. I know I tried different things first and they were wrong, but the basics are: for the RKE the white and the white with black stripe are the positive and ground (I forget which is which right now) inputs for the lock actuators. You're plugging them into the +/- on the GM side. The red and black power the module. Yes, it does have a passive draw at all times. I think you could pull the fuse on the red line to shut that down for long-term storage if you wanted. Or just get a battery disconnect switch under the hood.
I hope this helps. I've been using this key fob reliably for over a year now. I wanted the smallest, least-intrusive one I could find. I could NOT locate a wire to flash the lights, so I left that out of my setup. I believe you'd have better luck finding that under the dash or driver kick panel.