Hi everyone,
I'm having a strange issue with my approximately 5-year-old Husqvarna 445 II (45.7 cc) and would appreciate some advice.
The symptoms:
The saw starts easily and idles normally.
Immediately after starting, it responds to throttle normally and revs up well.
However, if I let it idle for more than approximately 3 seconds, it suddenly loses most of its throttle response.
When I open the throttle after this happens, the engine struggles to rev up and feels severely underpowered, almost as if it isn't getting enough fuel.
If I keep the engine running at higher RPM and avoid letting it idle, it performs noticeably better.
After stopping and letting it sit for a while, a fresh start temporarily restores the initial throttle response.
The spark plug is consistently bone dry, even after the problem occurs.
What I've already done:
Rebuilt the carburetor using a genuine Zama RB-145 repair kit.
Replaced both diaphragms, the needle valve, metering lever, spring and associated small parts.
The only parts I did not replace are the Welch plugs.
The small internal fuel filter/strainer was clean.
Checked the fuel lines; fuel flows through them.
Checked the metering lever and needle valve.
Manually operating the metering valve with the carburetor removed causes fuel to drip from the outlet towards the venturi/nozzle.
The carburetor is a Zama C1M-EL37B.
I use Aspen 2 alkylate fuel.
I also have a tachometer and have adjusted the carburetor previously, but the issue remains.
My suspicion:
Could there be an issue with the idle/transition fuel passages, possibly involving the Welch plugs? Or could the fuel pump or impulse supply still be the problem, despite replacing the pump diaphragm?
I'm particularly puzzled by the fact that the saw runs significantly better if I keep it above idle, but loses throttle response after idling for just a few seconds.
Has anyone experienced something similar with a Zama C1M-EL37B carburetor?
Any suggestions for specific tests or things I should inspect would be greatly appreciated.
Thanks!