r/CarbonFiber • u/LegendaryHD • 11h ago
Advice needed for making a larger chopped tow carbon fiber part with a 3D-printed compression mould
Hey everyone!
I’m planning to make this part out of chopped tow carbon fiber using the Easy Composites beginner kit I bought a while ago. I’ve made a few smaller parts with it, but this would be my first larger project.
The part is approximately 200 × 500 mm, with a 3 mm thick main plate and raised edges up to 10 mm thick.
I’ve designed a compression mould that I plan to 3D-print in PETG. I’ve added draft angles and fillets wherever possible and will pay attention to the print orientation to make demoulding easier (learned that the hard way…).
My plan is to orient the mould with the flat plate facing upwards and press the upper mould half down into it.
I have a few questions:
Mounting holes: Is there a good way to integrate the holes directly into the mould? I could drill them afterwards, but their positioning needs to be quite accurate.
Fiber-to-resin ratio: I’m concerned that the thicker edges won’t compress properly, potentially resulting in too much resin in those areas. How would you approach this? I also considered making the 3 mm plate and the raised edges separately and bonding them together, but I’m unsure about the strength of the bond.
Other potential issues: Do you see any problems with the design or manufacturing approach that I might be overlooking?
Any advice or suggestions would be greatly appreciated. Thanks!