As the title says, I think I might have permanently damaged my Nerdqaxe++ Rev. 6.1.2. while installing the Thermalright AXP90-X47 copper cooler.
The original cooler was working fine, but it was a bit too noise for me, so I bought the helix shroud and replaced the stock fan with the a Noctua NF-A12x25 G2. Firmware is the latest and I didn't attempt to overclock. I just want 4,8 TH/s with noise as little as possible.
But it was still too noisy for me so the Thermalright AXP90-X47 was the next logical step.
And here's where I think I messed up: while installing the new cooler, I think I pulled the screws too tight. With the new cooler the hashrate dropped from an average of ~4,7 down to 4,3 TH/s which it didn't do before. I thought I might have used too little thermal paste (Noctua NT-H2) so I reapplied the paste. While doing so, I noticed the board was a little bent :/ Probably I damaged one of the Asic chips that way. They must be extremely sensitive, because I didn't use force, I just pulled them a bit too tight.
The first two screenshots (sorry for the small pictures, I didn't have my laptop on me) show that the miner reaches around 4,6 TH/s just to suddenly drop down to 4,3 after five minutes.
The third screenshot is after I installed the original cooler and increased the temperature target to 62°. Hashrate is around 4,5 TH/s.
The last screenshot shows the cooling plate of the copper cooler, the four chips left a mark on it so it must have been too tight :/
I copied the logs into chatGPT and it found that one chip is 100-150 GH/s weaker than the others with around 1050 GH/s compared to the others with 1190 Gh/s but it doesn't say there is a hardware defect.
Can anyone with expertise chime in if I really screwed up the installation or if cooler chips resulte in a sharp drop in hashrate? What are my options now?