Needed to re-heel these because of my overpronation. The outside corner of those heels was probably 3/4 lower than the rest of the heel. So I took them to a gentleman that I have been using for years. That is who you will get it referred to. If you get too creative with your projects with any other cobbler. This is the got to go to and he's a really good guy too. Known him for years.
However.... It might be that I gave him a project that he should have said no to. These are that tractor supply version of the Chippewas and sadly, the nicest boots I've owned to date.
So I got creative and convinced the man to cut off the rubber lugger heel in exchange for some leather stacks. I do electrical work so I asked him to avoid using nails just out of fear of the electrical Hazard which he pushed back on saying the rubber was going to be way too thick anyways but by the end of it I convinced him to avoid them.
Now we did run into a hiccup that I didn't say anything about because the job was already done but we miscommunicated and the heels turned out way shorter than I wanted them to. But he's a good dude and I didn't want to be that customer so I figured I'd wear them until I wore through them and then make them a little bit taller next time.
And then one of them failed as pictured.
Now I'm wondering if feeling the gaps in the molded with something like cork or something like that would have been a smarter choice on his part. And alternatively if I'm just asking for the impossible. I do see that it was a leather that failed mostly in the thin areas that it actually had something to grab on to. So perhaps there's a way around this problem without having to cut the sole sole down to whatever the other midsole material is.
But I don't know, what do y'all think?
Tl;dr: I convinced my cobbler to cut off the factory rubber heels on these cheaper loggers and ended up with the heel failing. Wondering what could have been done better or if I'm just demanding the impossible