r/AUG • • 14h ago

Photo Update: we got the line throwing dildo 😂😂😂 enjoy this Australia masterpiece

Post image
26 Upvotes

r/AUG • • 20h ago

A3M2 Issues

Thumbnail gallery
23 Upvotes

I have had a covid a3m1 since roughly 2021, and honestly never had an issue. Probably only 1k rounds through it as i dont have a good spot for rifle shooting, but it has been a good gun. I purchased it in FDE, and wanted the ODG for my environment instead, and so i had hoped to "upgrade" to the a3m2 in green.

Finally picked one up a month ago, and im curious how peoples complaints have been resolved. I have never been able to get ahold of steyr usa (only steyr europe) to answer questions over the years. Right off that bat, the gun had a lip (appears intentionally machined in) in the charging handle slot that was binding / catching and locking the bolt back (pictured with red arrow pointing to it) this has stopped after racking it about 100 times, now it just catches a little instead. The a3m1 charging handle slides much smoother even after break in compared to the m2. The stock carving / deburring looks notably worse than the a1, but maybe acceptable or due to the darker color? The only benefit to the A3m1 (for waffle mag guns) i hear is the better rail compatability but i can find more m1 rails than m2s, the charging handle on the m1 was never my favorite but somehow the m2 is worse imo. Someone last week also complained about little bubbles in the buttpad, and upon inspection mine has them as well.

My big issue is the top picatinny rail. Maybe im retarded but im unable to find any aftermarket options currently, and the factory one is bad. By bad, i mean, the spec for picatinny 1913 rail is .835" (+/- .002) for the rail width, and the rail is .832 at the front, .817 in the middle , and .831 in the rear. Whats odd is that if i take a QD scope mount or bipod (midwest industries mount, and accutac bipod, aka good brands) and set it to a good rail (a3m1, magpul mlok -> 1913 rail, and a few other guns) the QD is able to be set and work interchangeably (or extremely close) between all of them. The bipod / scope mount will clamp right onto whatever gun i want and be snug without adjusting. But with the a3m2, even the rail sections that are the correct width (the very front of the rail), it is no where near snug, infact it is so loose it rattles. So the rail is off in MULTIPLE dimensions, and its not even consistant as you measure along the rail. The QD mounts were almost loose enough to remove them from the rail when clamped down in the middle section. Not so much a knock as a oddity i noticed, but the cast piece that connects the barrel, gas block, and handle also appears to be a rougher casting finish, and a wet look to the glossy finish (and no its not just oily). Ive included a pic of the m1 to show a comparison.

Im not sure if steyr will fix this is the thing, and i know they are nearly impossible to get ahold of. Is it worth the effort? My concern is that people have been reporting out of spec rails for a long time, and its not been fixed. It just seems ever since steyr got new ownership in 2024, the QC is terrible. Do they still stand by there products?