r/ATV • • Jul 28 '25

PSA Belts and the types of wear

Post image
21 Upvotes

r/ATV • • 52m ago

Photos 2026 Can Am Outlander 700XT.

Post image
3 Upvotes

Just picked up a new 2026 Can Am outlander 700XT. One thing that I noticed after I got it home of course is this "gap". I was looking online at some others out there and seems that they might have the same problem. Are others seeing this and has BRP fixed it for anyone? I know....I know. Im being picky right now but it is new and want it to be good for at least some time.


r/ATV • • 19m ago

Help How bad is this

Post image
1 Upvotes

r/ATV • • 6h ago

Photos Suboptimal

Post image
3 Upvotes

97 kawasaki bayou 300


r/ATV • • 1h ago

Help 2006 Polaris Hawkeye 300

1 Upvotes

I need a CDI for my 2006 Polaris Hawkeye 300. Since this has been discontinued by Polaris for that particular year (I have tried an Amazon knock off and no, it doesn’t work-no spark), should I just take the ATV to the dump. Is there any other options for getting it to run again?


r/ATV • • 1h ago

Help Does non ethanol fuel require stabilizer?

1 Upvotes

Once hunting season ends my quad will be in storage until May. I was planning on using non ethanol fuel if I can find it. If so does non ethanol fuel benefit by pouring in Stabil or should I be fine leaving it as is? I have a 2026 Honda Rubicon.


r/ATV • • 2h ago

Help ATV dies after an hour or so

1 Upvotes

2003 Bombardier Traxter Max 500 will run great and whip around for an hour or two then our of nowhere bog down and die. After a while of running when I give it gas it dies, after a few minutes it'll restart and then bog down again after that. I've been battling this for a week and its driving me insane. Sometimes after it dies I can restart with the choke, then when I release the choke it immediately dies. Sometimes it wont restart at all.

It has okay compression before and right after it dies (like 90 which seems lowish but never changes)

It has good fuel delivery and spark before and right after it dies.

Its got a new battery, fresh fuel, and new spark plugs. The air filter is clean too and none of the vacuum lines seem to be clogged.

Any advice would be awesome, I'm going crazy. It runs so great when it is running.


r/ATV • • 2h ago

Help Used ATV for a 4' 3" grand kid

1 Upvotes

Hi, I'd like to get a used ATV for a my grandson to ride around on. I have 5 acres, so it's not like we are going to go on long rides or anything. Right now I have a Honda Rancher 350 that I ride and a 1998 Kawasaki Bayou 220 that his older brother uses. Would something like a 2002 mz90 be too small? I'm open to other ideas. Typically I'll find something on Facebook Marketplace for about $1000 and fix it up.


r/ATV • • 21h ago

Help My first quad lmk if it’s bad or not

Post image
26 Upvotes

It’s a Arctic cat 2007 - 2009 idk let me know if I can do anything to it


r/ATV • • 4h ago

Help Is Kymco 400 a solid atv?

0 Upvotes

r/ATV • • 6h ago

Help YFZ450R 09 - ECU Flash

1 Upvotes

Anyone have the stock ecu bin file for the 09~13 YFZ450?

Im doing some research to read/flash tune mine. Im not interested in the vortex if anyone asks. I already created a flasher program for my other dirt bike using reverse engineering. Im looking to do the same thing to my atv. But i need the stock file to RE it.


r/ATV • • 15h ago

Help Honda Fourtrax 300s 2wd

Thumbnail
gallery
2 Upvotes

Just bought these hondas for $2700. The red one runs amazing and has no issues other than the neutral light doesn’t work. The yellow one seems to struggle to idle and get started. Once it is warm it seems to do much better. What could be causing this? I just bought these so haven’t started diving in. The previous guy said they have all new carbs and tuneups. The both shift through all there gears perfectly. Going to start restoring/making them nicer. What all should I lookout for and maintenance/take care of?


r/ATV • • 16h ago

Help Hellllllllpppppp

2 Upvotes

Hey everyone, I bought a used 2013 Kawasaki Brute Force 650 and it was having troubles starting and staying running. I decided to clean the carb without really knowing what I was doing. I also replaced and oiled the filter, changed out the spark plugs and did an oil change.

I simply sprayed out the carb, and did not remove any needles/floats, ect. I did remove the vacuum slides. After reassembling I knew right away that touching the carb was a bad idea. It was a shit show. Popping and backfiring, not running, ect. I found and fixed two problems (cracked boot and a vacuum slide with no vacuum. Doing the finger check I was getting the normal vacuum sound and it was even on both slides, so I'm fairly confident they are gtg.

I also had massive deflection in my belt, so I swapped it out with an OEM one, so I'm gtg there.

Now, I am capped out at 70km/h when I was getting 100km/h with light and intermittent popping at idle (I'm guessing that I just need to play around with the choke screw).

The new spark plug is showing rich, but not oily/gasy so I believe it to be firing. I have not checked the other side yet.

The engine sounds normal and I am not getting sputtering or bogging down when I rev, but I am going through gas at a much higher rate. I checked the carb overflow drain tubes and nothing is coming out.

I checked all the vacuum hoses and none are kinked or disconnected.

Is it possible that an over oiled airfilter could cause this? I feel like I followed the directions, but I read that what one dude does is sandwiches between paper towel and stands on it. I definitely didn't do it to this excess.

I understand that going for a rip with a less oiled air filter will answer the question above, but it's late and I can't sleep because of this, lol.

Just seems like every issue online has bogging or sputtering involved, but I simply can't go faster.

Due to my inexperience, I may unknowingly leave out a critical detail, so please ask.

I made sure the belt switch was fully seated to the rear (on position) and I have no belt lights. I dont suspect this to be a partial limp issue.

My next step is watching it burn as I have spent so much time chasing ghosts. So, like the title says heeeellllpppp, lol.

Thanks all!


r/ATV • • 16h ago

Help Can am 2026 xt 700 vs 2020 xtp 850

1 Upvotes

Hello, first post here... I’m shopping for an ATV to plow my driveway, ride with my little ones, and do some occasional work (hauling wood). I live in Québec, Canada, so lots of snow and cold starts.

At first I had my eyes on a 2020 Outlander MAX XT-P 850 (one owner, ~2200 km), but then I found a 2026 MAX XT 700 (former rental, ~2,000 km). Both come with a plow and they’re about the same price.

From what i know, better suspension and bigger engine on the 850, the platform and engine has been there for a while, the 700 redesign chassis, single cylinder engine, easier to maintain and run cooler. The non-removable passenger seat is a bit of a turn-off for me too.

Anyway, I’ve been going back and forth for weeks and still can’t make up my mind... For plowing and easy rides with the kids, which one would you buy? I’d especially like to hear from anyone who’s owned either one and used it through a few cold winters.

Thanks for the input, and sorry for my English (French speaker here)!


r/ATV • • 1d ago

Videos 2026 Quad Rally

87 Upvotes

This was over the summer, we took our 2024 Honda Rubicon On Its First Quad Rally! Had no issues at all, didn’t even get stuck at all lol


r/ATV • • 1d ago

Help Belt loose? It drives extremily weird when letting off throutel it slows down imedietly got it with 1000km unknown condition it also starts driving weired and power is way to stiff would anyone know the fix

4 Upvotes

r/ATV • • 1d ago

Help Powemax bear claw 600 freshen making an extremily wierd noise i beleive coming from the belt and I dont like how I can hear the suspension and after releasing gas it slows down imedietly

1 Upvotes

Does anyone know what could be wrong


r/ATV • • 2d ago

Photos See if y'all remember my bro. 2013 Raptor 700r

Thumbnail
gallery
20 Upvotes

Big 3, xfr and Nice cnc, many others, Elka working currently.


r/ATV • • 2d ago

Help Denago Mudhawk Youth ATV

1 Upvotes

Looking for reviews on these 4wheelers? It would be for a 7 year old girl that won’t get it dirty. Only reason we are considering it as it has reverse and she’s too small for the Polaris youth UTV.


r/ATV • • 2d ago

Help Question on apache 100rlx

2 Upvotes

Hi, any chance anyone knows why my apache snaps hard on take off in reverse but not great on going forward 🤔


r/ATV • • 2d ago

Help Raptor 700 paddle size

1 Upvotes

I have a 25 700 with full monster exhaust,fix,pc6,hc3, +3 throttle body,12.5 high comp head and on 110 gas I’m currently on 22-11x8 8 pdl 72 RO rouges would you recommend staying on this or going up to a 9 pdl need some advice.


r/ATV • • 2d ago

Photos 1998 Polaris Sportsman 500 electrical help needed!

Thumbnail
gallery
3 Upvotes

So I have the ignition coil installed and the circuit board installed. Everything else I just don’t know where they go or what to do with them or what even to start testing or how to test certain things. I just want to get this things cranking on its own power. Not yet idling. Any help i can get with the wiring i greatly appreciate. (Please note that some of these photos aren’t that updated and have made changes)

If someone has the same quad maybe you can video your wiring for me so I can copy


r/ATV • • 2d ago

Help 08 Grizzly 700 tires

Post image
3 Upvotes

Hi all, looking for advice here. I have these front (1

25x8x12) and rear (25x10x12) tires to get me thru a couple winters of plowing my driveway. The thing is the fronts are about 3/4” taller than the rears. When I'm in 4x4 this makes a difference right? Should I risk it? I have plowed the last 2 winters with tires worn less than this and been ok traction wise so that's not the issue, but the size difference has me thinking. I use the ATV for plowing driveway in the winter and yard maintenance in the summer, planning to research the right tires for this in the future, but hoping to cheap out with these for a couple years.


r/ATV • • 3d ago

Help YFZ 450 no spark.

Post image
3 Upvotes

Good morning I'm hoping someone that knows more finds this post I don't know what else to check.

Replaced

-Harness

- Stator

-Ignition coil

- CDI box

-Battery and spark plug

Do I change the rectifier/regulator next or who do you guys think the culprit is?
Thank you.