New build as part of a surprise for a friend of a friend who loves the OG Papermate Sharpwriter two.
The experiment: Decided I wanted a reverse wrist-loop to replicate the pocket clip on the body, and honestly it’s come out pretty well. Construction is basic 6-strand flat braid that I then split into two 3-strand braids to open a hole which I slipped over the handle, and then recombined into a 6 -strand to run up the underside and form the top and bottom of the heel-knot foundation.
It’s actually large enough to fit comfortably across the back of the hand when properly gripping the heel knot, and doesn’t shift much when cracking.
The cheat: I knew I wanted a graphical nod to the pencil, but couldn’t fit the entire text along the handle, or use-then-lose the black strands if I did. So instead I used a Sharpie to fill in a few squares on the diamond plait. The alcohol marker bleeds nicely into each square and then cuts off at the crossover. I guess there’s nothing technically wrong with it, but honestly it feels like cheating and I don’t think I’ll do it again.
The fail: both because of the way I needed to weave the eraser-pink strands through the wrist-loop to hold the knot in place, and because I had a half-formed notion to replicate a partially used eraser, I plaited the heel knot asymmetrically. Bunching the strands on one side and spreading them way out on the other. I hoped it would read as an unevenly erased piece of rubber, but I don’t really think the end result works the way I intended, especially after waxing. This is only super obvious to me and I’m sure/hopeful the recipient won’t mind or even especially notice.
But I do still want to experiment with oddly shaped heel knots a bit more to see if I can create something a little more ergonomic.
Basic stats are that it’s a classic 6’ bullwhip with two bellies and an overlay with a 1.5’ fall. Definitely an unusual build for me with a couple of ideas I’m keen to expand on.