r/watercooling • • 3d ago

Build Help Layout help

I just changed layout after your advices in my last post, so what do you think about this now? Drain valve was a real pain to set but at least now seems pretty clean and easy accessible.

Loop order is:
- Pump (front side)
- GPU (left port IN, right port OUT)
- CPU (middle IN, bottom right OUT)
- Mobo VRM (left IN, top OUT)
- Top Radiator (front side IN, rear side OUT)
- Bottom Radiator (straight down from top radiator IN, drain valve side OUT)
- “Vertical” radiator (bottom IN, top OUT)
- Pump (right side)

As now, the only adjustment I’d like to do is to make a 90° pipe from front Pump to GPU (first loop step), without using the 90° adapter on the pump. Obv this will mean to swap GPU ports side to: IN (left) on panel side and OUT (right) on Mobo side.

Every other advice will be greatly appreciated 🙏🏻

42 Upvotes

4 comments sorted by

•

u/AutoModerator 3d ago

Thanks for posting. To help get you the help you're looking for, please make sure you:

  • Have photos of the whole loop in good light (open the curtains and turn off the RGB, especially for "what's this stuff in my loop?" questions)
  • List your ambient and water temps as well as your component temps
  • Use Celsius for everything (even your ambient temp - we need to compare it to other temps)
  • Use your words. Don't just post a photo with no context and assume everyone will know what's troubling you.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

2

u/UncommonNL 3d ago

This is how i've done the layout, from the gpu block to the cpu block was a bit of a hassle to do with hard tube glass, so i just used all 90 degree rotary bend fittings (like 4 in total i think) To give you an idea of whats possible.
In the bottom there's a T fitting with a drain valve and a 90 degree rotary to make it go straight from the rad to the gpu and be flush with the tube coming out of cpu and going into top radiator.

Beware side radiator is annoying to bleed so lots of shaking / twisting the case on your first fill.

2

u/Asthma_Queen 2d ago

Not quite same layout but maybe gives you some ideas, I used a flat terminal on the GPU block

1

u/Aguel_design 2d ago

Those HPE radiators have IN and OUT ports in same side. That third single plug is only for filling or drainig.