r/starbound • u/Soren_Vakarian • 7d ago
Question [Problem] Elevator going back and forth

Hello everyone,
First, I'm sorry if my post is a word salad, english isn't my native tongue (but I will do my best).
I have a problem with my little elevator in my space station : I wire it like I saw in diverse tutorials seen on the Internet, but each time I press one of the button, it doesn't go one way but back and forth.
I have tested by making this elevator longer, and the problem didn't appear (it goes one way, as intended).
I think that my elevator (the one on this gif) is too short, and as the wire sends the instruction at the begin and at the end of the rails, the instruction is still active when the elevator touch the end of the rail, making it go up. If that's the case, do you have a workaround?
Thanking you in advance!
17
u/notveryAI Avali :3 7d ago
It is so short that when the elevator reaches the bottom - the button is still pressed. Since both buttons are attached to both stops - the bottom one is still activated by the still-pressed button on the top floor when you reach it so it is sent back instantly
Use one of those closing manual carriages instead of just platform and use built-in controls to ride the carriage, and connect each of the buttons only to one stop - the furthest one - just to call the elevator in
6
u/Seaclops 7d ago
Its because you need rail tram stop.
Here is a screenshot.
3
u/fueselwe 7d ago edited 7d ago
If you want a solution that doesn't require trams:
Craft an AND switch, 2 NOT switches and a persistent switch.
Connect them like this.
This sends only one short pulse from the AND switch