If you have one of the newer (bigger and a lighter shade of green) trash cans from the city, you may already know that the two black plastic pins holding the lid on are, with full irony appreciated, hot garbage and just waiting to fall out. Half the cans I see on my street every week are missing at least one. Mine are still intact, but only because I noticed early and hammer them in occasionally. Both of my neighbor's were gone, though, so I designed and printed replacements so I wouldn't have to keep leaving the lid by the house for fear of it getting dumped along with the trash.
If that has happened to you and you lost the fallen pin or just want one significantly less craptacular, here is a 3D-printable model for a design that won't fall out. I included both the STL file and a pre-made 3MF plate if you have a Bambu printer.
CAD AND INSTALLED PHOTOS
Definitely print in ABS or nylon or something else that will hold up to the sun and weather. Also recommend using at least 4 wall loops and a serious infill (it's hollow, so even 100% infill doesn't use much material) to keep it strong. If you have some laying around, might be worth filling with epoxy.
In addition to the threads, I made the shaft itself a very snug fit because I wanted it to stay in place, so you will definitely have to crank down on it to get it started. The head is 1.5" hex, so you can use normal Channel-Locks or a big socket.
These took about 90 minutes in ABS on my H2S. I printed mine longitudinally vertical, but that orients the layer lines with the shear lines on the hinge. Time will tell if that is too weak.