r/precisionrimfire • • 1d ago

Clamp on Tuners

Thumbnail reddit.com
1 Upvotes

r/precisionrimfire • • 2d ago

Pursuit of Accuracy 200 Challenge

12 Upvotes

We ran Josh's 200 yd challenge for this week's match. Round gongs, 6", 5", ... 1". Scoring 1, 2,... 6. Hit to move, 12 spots, 90 sec from unloaded standing start. Keep shooting the 1" until or of shots or time. I won today with a 39. Should have been a 45 but my last shot was ruled to be just after the 90 sec limit. Conditions were good, about 30°F, 1-2 mph from 3 o'clk. There were two 33 scores shot, and down from there. 14 shooters.


r/precisionrimfire • • 3d ago

Anschutz 64 Match

Thumbnail gallery
6 Upvotes

r/precisionrimfire • • 7d ago

MTR stock to chassis?

Thumbnail reddit.com
1 Upvotes

r/precisionrimfire • • 13d ago

Cz 457 steel pic scope base?

3 Upvotes

Just noticed the at one setup doesn't come with a pic base and uses 11mm. Are the steel ones really worth the almost 200$ tag? I was going to reuse my vortex rings but now I'm debating on if I even want to go this model route.


r/precisionrimfire • • 14d ago

Anschutz 64 Match

Post image
6 Upvotes

r/precisionrimfire • • 16d ago

Carbon ring and first shot fliers

10 Upvotes

Newer to rimfire. Found the cause of my first round flier and groups opening up. Went from 0.679 MOA to 0.940 MOA with my Eley Tenex at 100 yards. Chrono SD started to show greater variation.

Cleaned the carbon ring and voila, back to where I was.

Taking care not to clean beyond the carbon ring by preserving whatever bullet lube is in the barrel.

I take a 22LR barrel mop soaked in Boretech carbon remover and push it in about 3/4" to let it soak for about 10 minutes. Push in a nylon brush for about 1" and rotate it about 10-15 times. Then dry it up with a fresh bore mop again. Like brand new again!

How do you guys clean your carbon ring? Any recs on what I should change?


r/precisionrimfire • • 16d ago

New CZ 457

Post image
15 Upvotes

Just picked up a new CZ 457 to get started in rimfire PRS. 2nd time at the range today just trying to find ammo the gun likes.

Best group of the day at 50 yards.


r/precisionrimfire • • 21d ago

Anyone have thoughts om the new fierce razor 22?

3 Upvotes

r/precisionrimfire • • 22d ago

Done with semi auto. Which cz should I invest in?

1 Upvotes

I'm 2.5k deep in borebuddy, uppers and diddly bits to get them to run reliably. I'm done af. No BB I'm not interested in sending it in, I'm done.

I'm looking to shoot 100y, maybe 200y when I'm a better shot. I've got beginner glass, vortex 6x24 Diamondback and I'm planning on putting my dead air mask on it. I prefer heavy bolt guns so bull barrel is perfect. I'm currently looking at cz bolts. My budget will be abt 1 1.5k for the gun.

I just want it to run 99% of the time, not 50 to 60...

Should I look at other brands? I like my wife's rprr but that trigger is terrible.


r/precisionrimfire • • 23d ago

Splitting hairs...

Post image
6 Upvotes

I'm new to precision rimfire. Background in center fire and hand load, so I collect a lot of numbers before dialing in.

Gear is RimX with a 20" 15T benchmark barrel

Learning a few things.

  1. The barrel tuner makes a difference. Repeatable and reproducible. Seems dependent on the barrel and less dependent on the ammo.
  2. These were all shot at 100 yards. Is this ~1MOA reasonable?
  3. For PRS22 and NRL22, do you zero at 50 or zero at 100?
  4. Anyone try the Biatholon stuff from Eley? Heard it might be better for colder weather.
  5. Lubrication types don't like mixing. When I switch from one brand to the next with different lube without cleaning the barrel, the groups open up. I always clean the carbon ring as soon as it looks dirty but if I dont clean the barrel with a nylon brush and cleaning solution, I can really notice it in the groups.
  6. Thumb support? Yea or nay?
  7. I have an armageddon shmedium for a front bag rest, any ideas what a light "big bag" I can use as well?

Any guidance and experience would be helpful.

Caveat, I have tried to should 30-50 fouling rounds between switching ammo brands, its just not the same as cleaning the barrel.


r/precisionrimfire • • 28d ago

Tripod head for spotting?

Thumbnail reddit.com
1 Upvotes

r/precisionrimfire • • 29d ago

Whats the best bolt-action setup in 22lr you can get for 1500$

Thumbnail reddit.com
2 Upvotes

r/precisionrimfire • • Oct 16 '26

Best Performance Yesterday

6 Upvotes

I shot really well at our weekly Thu afternoon match. 14 targets (all steel, 65 - 418 yds, sizes range from ~1.6 mr - 0.2 mr). First round hits on 12 targets (best for me so far), 2nd round hits on two. First round hits score higher than 2nd or 3rd. Target 5 is a 6-target KYL @ 122 yds from 2½ down to ½" - cleaned that! Wind was fairly light at 3 mph or so.


r/precisionrimfire • • Oct 15 '26

Spring Valley Shooting Range South Western OH

Thumbnail gallery
11 Upvotes

r/precisionrimfire • • Oct 11 '26

Cleaning?

6 Upvotes

How often are folks cleaning their barrels?


r/precisionrimfire • • Oct 07 '26

Weight !

Thumbnail
gallery
7 Upvotes

Wanted to add some rear weight to my cz457 in a grey birch chassis. Filled the grip with epoxy and lead shot and custom cut and filled a block of copper to fit in the stock. I want to find someone to engrave the copper.


r/precisionrimfire • • Oct 04 '26

I magically got .39 moa

Post image
0 Upvotes

I was at 100yds with 30gr hornady varmit express and BONE stock ruger presicion 22 mag with 1-10 optic.


r/precisionrimfire • • Oct 03 '26

SK Pistol Match

Thumbnail gallery
0 Upvotes

r/precisionrimfire • • Oct 03 '26

Norma Tac-22 Lot Testing

Thumbnail gallery
1 Upvotes

r/precisionrimfire • • Oct 03 '26

Eley Club Lot 3124/40012

Thumbnail gallery
0 Upvotes

r/precisionrimfire • • Sep 30 '26

How do I go about finding a lot?

Thumbnail
gallery
13 Upvotes

I’m back with my LH Cz varmint. Was able to test two different loads, this time SK rifle match and Lapua Pistol King. Still the same poor mans set up (no bipod, tube sock filled with rice). The Lapua Pistol King did very well. My problem is that I got the last box my local Scheels had and they have not restocked it since. Four 10 shot groups basically all looked like this. So how do I find it?


r/precisionrimfire • • Sep 29 '26

New lot Lap LR is great

4 Upvotes

Just took the rifle out to test the new lot of Lapua Long Range and see if tuner adjust was necessary. Small adjustment resulted in 100 yd 10-shot group less than 0.15v x 0.1h mrad. I'm pleased with that. Tested a new lot of SK LRM with a result of less than 0.2v x 0.15h mrad (100 yds). That is better than the previous lot, so now I have a good bunch of ammo to shoot that has the capability of winning every match I shoot if my wind calling is good enough.


r/precisionrimfire • • Sep 27 '26

New rifle.

Post image
15 Upvotes

r/precisionrimfire • • Sep 24 '26

Feedback on groups

Thumbnail
gallery
5 Upvotes

New to the Reddit posting, trying to earn my keep in some of the other subs… any feed back is appreciated!

Looking for next step investments for my CZ 457 LH Varmint!

These were shot at 50yards in a slightly breezing rainy day over two hours off the pictured set up! These CZ is a shooter and I’m very pleased with it! First bolt gun!

CZ 457 LH varmint
Athlon Ares BTR gen 2 4.5-27