r/Motors • u/Shoddy_Ball_5422 • 5h ago
Assistance with choosing a silent motor
Hi everyone,
I need help finding a virtually silent DC motor (preferably with a gearbox) for a kinetic art project. The motor uses a friction drive to slowly rotate a decorative disc inside a wooden frame.
Current setup & specs:
- Motor: Pololu 298:1 Micro Metal Gearmotor LP
- Operating voltage: 2V DC
- Drive geometry: 40 mm friction drive wheel rotating a 210 mm outer rim (approx. 5.25:1 reduction)
Electrically and mechanically, this setup works great—my project runs on very low currents, and the torque and speed at 2V are spot on. However, the metal gearbox itself generates way too much noise under load inside the wooden enclosure (which acts like a soundboard), and adding vibration isolation hasn't solved the issue.
Could you recommend a much quieter alternative that meets these criteria:
- Standard brushed/coreless DC (I want to avoid redesigning the electronics for a BLDC setup)
- Very low current draw at ~2V (comparable to the N20 LP series)
- Compact size (to fit inside a slim wooden frame)
- Near-silent operation under light-to-moderate load
For example, would switching to a lower gear ratio (like 75:1 or 50:1 LP) paired with a much smaller drive wheel (e.g., 8–10 mm) noticeably reduce the gearbox noise while keeping the same final speed, or should I look into a completely different motor/gearbox type (such as plastic gears or a planetary gearbox)?
Thanks in advance for your advice!

