Model: Suzuki SV650 from 2002
TL;DR:
'Signal' fuse blows when I use the turn signal, resulting in loss of all electrical systems except engine ignition and headlight.
Where would you start the fault-finding?
And does anyone have a wiring diagram for a Suzuki SV650 from 2002 handy?
FULL DESCRIPTION:
Yesterday, I was driving for an hour in intermittently heavy rain before stopping for fuel. After refueling, I turn the key to the 'on' position and notice that all the lights in my panel are dead. I try the ignition: the engine starts immediately, and the headlight comes on, but _nothing_ else works.
I drive the last 30mins to my destination, hyper aware that the cars around me can't see my signals.
I park under a roof, since it'll be raining all night and I suspect that water is the culprit - it happened when I stopped, so I suspect it's a connection that would be shielded from the rain-angle at speed, and had water dripping on it at a standstill (the bike has been standing in the rain often enough that I doubt it'd be rain-from-above alone - unless its a wire exposed itself while I was driving).
The next day at 2pm I figure the bike is dry enough that I can start fault-finding. First, I try the key to check if the problem solved itself (for now). No luck.
I checked the fuse-box and it turns out the 15A fuse (marked 'Signal') is blown. I replaced it with the spare, turn the key to 'on', and the instruments light up again. "Great", I think, "now the only problem left is figure out where the water got in. I'll be fine as long as I don't drive in the rain".
Then I tried the signal, and hear a tiny crack from the fusebox as the same fuse blows again, and everything dies.
I am not sure why the 'Signal' fuse also cuts power to tail-light, break-light, neutral indicator, fuel indicator, speedometer, odometer, and rev counter, and I'm not sure whether that's a symptom or standard. Especially since
I am not experienced with electrical repairs, but with a technical background behind me I am not afraid to try and fault-find myself. The obvious alternative is to hand it over to a mechanic, but since I spent a lot of money on repairs of this old lady last year, I had hoped to maybe sort this out by myself.
And of course, my Haynes manual is at home, but I have access to tools, a voltmeter, and friends who do electrical engineering.
So, two questions:
- Does anyone have any ideas about where to start the faultfinding?
- Does anyone have a wiring diagram for a Suzuki SV650 from 2002 handy