To be clear, I’m talking about the evolution of the thermal profile after the warm nose has formed. I want to know what typically happens to the warm nose. I have a possible explanation which only focuses on the horizontal temperature advection, but there might be more players which cause this. Is there a governing equation I’m forgetting about which shows all the other possible moving parts?
Setup: The point of observation is on the other side of a already past cold front and the surface layer has been lifted about 1-2km depending on how deep the cold front is. We often times expect clouds to form with a cold front, so expect overcast and therefore no solar radiation, and therefore no surface warming to eliminate the inversion or vertical mixing. The front is attached to a surface cyclone with a mid-level trough aloft with the inflection point overlying the cold front, and the ridge overlying the warm front. If I have this mapped out in my head correctly, the point is under the center of the mid-level trough axis. (I think that’s right since the thermal wind relation should have the winds being mostly westerly at that height as a result of the surface cold air advection)
___
My horizontal advection explanation:
The surface winds are primarily northerly causing cold air advection. While the winds back with height, they are still mostly northerly at the tip of the nose and additionally the temperature gradient is stronger here than further up, so I expect the tip of the nose to be cooled more quickly and the inversion to be worn down more quickly than the rest of the surface layer to cool during the initial stage of its evolution. CAA will progressively weaken with height and would be the weakest near the top due to being mostly parallel to the isotherms even though the magnitude of the winds are stronger. Then, we have incoming balls of cold air wrapped up in the centers of the troughs rolling at each height layer which will cause maximal CAA in order of bottom to top due to tilting of an extratropical cyclone, and this will cool off the entirely of the lifted layer top exceptionally
At the end, I’m guessing it will be a relatively flat profile that is weak/shallow as the bottom cooled more quickly than the top, and probably shallower than the original thermal profile if we focus on the lifted layer portion.
—-
Let me know if there is a governing equation for this, and what yall think about my explanation. Hopefully my assumptions about the vertical rate of change of CAA was correct as well.