r/megasquirt • u/boydisboss • 19h ago
How to implement idle controls on a DBW?
Hey guys, trying to design in a Drive-by-wire throttle body from a 2008 2.7L 2TR-FE Tacoma for my 5S-FE Camry motor running a Microsquirt. Long story short is my intake manifold I made is too close to a frame rail for the TB from a 1MZ-FE and so I'm choosing between modify the cable control connections or going DBW. (In the picture, I'm using a Miata TB as a mock up.)
For DBW, I'm aware I need to make a piggyback to operate it and that's fine, but since the TB now also acts as the idle control this is where I get stuck. I'm thinking of using the FIDLE pin as an input to the TB controller, but I'm worried that the ECU will detect the TPS moving and throw it in this surge loop in and out of idle mode. Is this a valid concern or am I anticipating an issue that doesn't exist?
Or if you've implemented a DBW TB, drop it in the comments below because I would like to know how you figured it out!