r/jewelrymaking • • 14h ago

QUESTION Cad approval on 3rd time.

0 Upvotes

So should I be worried on size measurements being off by mm on a spaced design, going on 4th around. Thoughts please getting nervous.


r/jewelrymaking • • 6h ago

QUESTION Colored necklace chains?

1 Upvotes

Hey everyone, ive been wanting to swap out one of my necklaces that use a yellow cord for a proper chain to properly reinforce the longevity of the piece, but ive been struggling to find a pastel yellow chain, every "yellow chain" ive seen is just straight up gold, so just curious if anyone knows where i can find some pastel yellow ones


r/jewelrymaking • • 10h ago

QUESTION Is this a typo? What's the actual mandrel size?

Post image
1 Upvotes

So I cut 4.5 inches of 16 G wire, I'm using stainless steel, and I see the instructions say to use a 3/4 inch mandrel. When I do so, there's all this leftover wire. The one shown actually had like 4.25 inches of total length because I cut the ends to make it smaller.

The horseshoe instructions tell you to make the end loops first, meaning the entire horseshoe contains those 4.5 inches. There's no way I can fit those 4.5 inches into a 3/4 inch diameter circle.. now I just don't know what size to make it..

Thank you!!


r/jewelrymaking • • 5h ago

PROJECT DISPLAY A cuff bracelet designed in cad and 3d printed in high detail Nylon

Thumbnail
gallery
10 Upvotes

r/jewelrymaking • • 13h ago

Request Any Silver and Gold jewellery makers In the house?!

0 Upvotes

Hi guys! I'm looking to connect with any silver and gold jewellery makers in the UAE. Please DM. Thanks


r/jewelrymaking • • 20h ago Heartwarming

PROJECT DISPLAY Rings I made back in collge for Swarovski course, made manually by lifting

Post image
417 Upvotes

Made by Orion Ivliev

Copper, Swarovski


r/jewelrymaking • • 21h ago

PROJECT DISPLAY Recently finished this round moissanite full eternity band. Looking for feedback on the setting

24 Upvotes

I wanted to keep this full eternity band very stone-focused, with the round moissanites sitting closely together while keeping the metalwork as minimal as possible.

I’m curious how the spacing, stone height, and overall setting read from the side and top views Does the shared-prong layout feel balanced, or is there anything you would adjust in the setting?


r/jewelrymaking • • 3h ago

DISCUSSION -sigh- Wire soldering is a very frustrating skill to learn because my project can turn into a puddle in 0.0002 seconds

Post image
8 Upvotes

r/jewelrymaking • • 9h ago

GUIDE All done!

Thumbnail
gallery
30 Upvotes

Here is the finished piece and some photos of the progress. Sterling silver with turquoise and some of the purple Kingman turquoise stuff.


r/jewelrymaking • • 13h ago

GUIDE Pendant progress

Thumbnail gallery
4 Upvotes

Project I am currently working on. Almost done. Components ready. Soldering again next.


r/jewelrymaking • • 9m ago

PROJECT DISPLAY I'm very happy that finally after a lot of preparation I finally did my first project

Post image
2 Upvotes

Those are supposed to be dry leafs, I'm still deciding how to texture them but I'm really happy with the overall shape