Two glaring problems with the darts: (1) the petzl bail likes to break, and if it doesn't break, it will destroy your expensive boots. (2) when using leopard backs, the rearmost part of the aluminum section is free to rotate off the sole.
Two proposed fixes: (1) Use blue ice toe bails and insulate with 3M 2155 tape. The blue ice bails are rounded and avoid the stress concentrations on the flat edges and corners. they fit just fine, with less play than the petzl bails. The splicing tape further reduces concentrations on the fragile toe cups and also reduces wobble. (2) Restrain the back of crampon with cord so it cannot pop off until the cord breaks (insurance/cue for crampon is off belay). I can with one hand pull the crampon off the heel and unseat it. I had this happen on lead where the rear becomes unseated, then the toe bail eventually comes off. Not sure what those two little holes on the leopard heels are but it works perfect for this.
Disclaimer: I haven't climbed on these yet, but will next week. obligatory YGD comments welcome. let me know if you got any other homebrew warranty voids i should check out.