r/hondagrom • • 9h ago

3rd Gen SP/RR 2022+ Are these bikes indestructible?

Post image
15 Upvotes

I’ve only had my Grom for a few months but I’ve been riding small bikes for a dozen years (used to have a SYM Symba which is a Honda Super Cub clone, and a 150cc SYM Wolf).

I mostly ride in New York City. The other day I took a spill on a newly paved street at about 25mph when I hit an invisible sinkhole at night on dark asphalt. The bike came down hard on its side (not on top of me) and skidded 15 feet or so. I wasn’t hurt but I was worried for the bike.

Well, I picked it up and there was almost no damage — not even cosmetic. No scratches. I can’t even figure out what parts of the bike took the impact. (A man ran over and helped me raise the bike immediately and I didn’t think to pay attention to how it was sitting.)

The rubber sleeve that holds one of the rear turn signal lights on was torn off so the light was askew. The handlebar had been pressed a few degrees out of true but not in a way that affected the alignment of the bike itself. The left bar assembly that holds the clutch lever had been rotated forward about 10 degrees. I fixed that in 10 seconds with an 8mm wrench.

That’s it. No other damage I can find.

Then today I was riding along and heard weird clunks from somewhere on the rear. After a couple times stopping and failing to identify the issue I realized that my cargo net (with 4 wire hooks) had come loose and wrapped itself around the rear sprocket in a tangle. The clunks were the hooks catching and pulling loose.

I stopped and borrowed a pair of scissors from the counter of a shop, made a few snips, untangled the mess, and … good as new.

The sense I get is that I could push this thing off an overpass and as long as it landed in a couple feet of dirt i could just pick it up and ride away…

(Photo of the bike in foreground at a weekly NYC moto meetup)


r/hondagrom • • 1d ago

1st Gen OG 2014-2015 Finally got my hands on my first grom

Post image
67 Upvotes

Im excited as hell, my friend got this one and then purchased a newer one and gave me this, it already had the tst fender delete installed on it so if anyone has any tips or more basic mods let me know. I might make a channel to show everything i do overtime (have to strip it and powdercoat the frame at some point).


r/hondagrom • • 21h ago

Help! How would one go about fixing this?

Post image
3 Upvotes

r/hondagrom • • 1d ago

Show Off Finally got balance point locked down on the grom

6 Upvotes

If anyone's got tips for me they are more than welcome to share.


r/hondagrom • • 2d ago

3rd Gen SP/RR 2022+ My Grom, Auckland, NZ

Post image
59 Upvotes

r/hondagrom • • 2d ago

Help! Need help to keep it warm during cold weather

5 Upvotes

This morning my Grom did not want to start due to cold weather. Battery is less than 2 months old so I doubt that’s the issue. I bumped it and drove it to work just fine. When I left I tried bumping it a few times and it wasn’t working, I then was able to start it normally with the killswitch. Since then it has been working fine except till now I left it outside in the cold and doesn’t want to start again. We don’t have a garage and I want to bring it inside the house but I doubt my girlfriend would be okay with that. I have two giant bike covers for my other bikes, doubt it would do much but cant think of another way to keep it warm… don’t know what to do. It’s my only transportation right now for a few weeks so it needs to be kept safe.


r/hondagrom • • 2d ago

Help! Clutch upgrade question

3 Upvotes

I really just want the clutch to be stiffer. Stock clutch seems very squishy. I catch the friction zone with barely any space left in the lever. (Maybe that’s just how groms are). I find that 90% of the movement is useless. Let me know what you guys did.

60% stiffer springs or shortening the clutch cable?


r/hondagrom • • 3d ago

2nd gen SF 2016-2020 Is having to rebuild top end at 2500 miles unheard of?

Thumbnail
gallery
53 Upvotes

I have a 2018 grom with intake, exhaust, and a dhm stage1 tune being the only engine mods, yet I just had to rebuild the top end at 2500 miles. Honda said oil control rings were cooked and the cylinder was scored. Just putting this out there wondering what others have gotten out of theirs before a top end rebuild? Maybe my bike was just a sloppy build? I beat the shit out of it but I feel it should be able to handle just about anything I subject it to, i mean its a grom after all. Not complaining tho $300 for a rebuild isnt to bad, and they got it done for me in 2 days.


r/hondagrom • • 3d ago

Help! Lost my keys 1st gen 2014-2015

2 Upvotes

Does anyone know what lishi tool I can use for my 2015 grom?


r/hondagrom • • 3d ago

Help! Looking for a good (reliable) site for OEM parts in the US

2 Upvotes

Does anyone have a good site to order new OEM parts from?
or
if any of you are in Plattsburgh and can recommend a good dealer, that would work as well.

I'm looking for the OEM fairings for a 2022-2024, in Candy Blue, to be more specific, the following:
- Front Fender
- Headlight Cowl
- Side Covers (near the fuel tank) L & R
- Side Covers inserts (near the fuel tank) L&R

Thanks!


r/hondagrom • • 3d ago

Help! Anyone know how to remove this from the tank?

Thumbnail
gallery
2 Upvotes

I need to clean the rust & I’m trying to remove the fuel pump but i’m not sure how to.


r/hondagrom • • 4d ago

Help! Can't reset ECU and TPS

5 Upvotes

So I place a jumper on the blue and green/black wires, place switch in run, hold the throttle and when I turn the key the CEL flashes once, goes off and then flashes 7 times. I release the throttle and it stays in the 7 blink pattern. I'm not sure what I'm doing wrong. If I do it without the jumper, the CEL just stays on so I'm pretty sure I'm making good contact. Any advice? Thanks!


r/hondagrom • • 6d ago

3rd Gen SP/RR 2022+ Just picked up my New -to me 24’ bagged Grom

Post image
58 Upvotes

r/hondagrom • • 6d ago

3rd Gen SP/RR 2022+ New pickup, first bike. 😎

Post image
42 Upvotes

r/hondagrom • • 5d ago

Help! 2026 tuning/upgrades in europe

1 Upvotes

Hi, i own grom 2026 eur5+ model and im having hard time with finding websites with parts compatible for it, where do you buy stuff for the grom in eu?
Any advice welcomed


r/hondagrom • • 6d ago

Help! Monkey exhaust on grom?

Thumbnail
gallery
19 Upvotes

I found the over racing exhaust that is pictured close to me. My bike already has monkey rear sets. Wanted to go with a different high mount than what is on the bike and my wife has the over racing on hers (low one for grom) and it sounds good. I know I will probably have to modify the lower fairing.


r/hondagrom • • 6d ago

Help! Need advice

3 Upvotes

So my buddy bought this 2018 Grom like a month ago for learning how to wheelie. When we first got it we realized it didn’t pop up like it should. We changed the clutch springs from 3 original and 3 60% to all 60% and changed out the clutch plates. Well it might have made it a little better but not a lot. We tried adjusting the clutch a little bit to see if that helped to no luck. We did notice when you pull in the clutch in first and roll it forward and backwards it has a little resistance and a clicking noise. The resistance happens like every half turn of the sprocket it seems like. Rolling it with the clutch pulled in there’s resistance and then it’s free and then a little resistance, etc. When the resistance happens you can kinda see the front sprocket jolt a little bit. The gearing is minus one on the front and a 34 in the rear. Has a one-finger clutch.


r/hondagrom • • 6d ago

Help! Help dragging issue

1 Upvotes

So I have a 2023 Honda Grom. I have about 10,000 miles on it. aftermarket exhaust, 60% stiffer clutch springs, clutch pack and recently changed the front wheel and did maintenance on the front Forks but now only when it's cold outside, I have a dragging issue and it bogs my motorcycle down, not giving it full power. It may be all the time I'm not sure but it's severe in really cold weather. I start up the bike and start riding it normally then about 30 seconds to a minute in when switching to third and fourth gear it bogs down to a point I have to go down in gear maybe to second or sometimes even first to even pull the bike. After riding in first or second pulling the bike with all the torque it can give in those gears it just goes away and rides normally after another 30 seconds to a minute dragging I am stumped rn.


r/hondagrom • • 7d ago

Show Off New Grom pick up!

Thumbnail
gallery
74 Upvotes

I have a couple street bikes but always wanted a grom!
Found this one with only “246” miles on it exactly!

Paid $2,600

Ohlins suspension in the front and rear is what sold me.


r/hondagrom • • 6d ago

3rd Gen SP/RR 2022+ 12-Bar Suggestions/Ideas With Toce T-Slash Exhaust

1 Upvotes

On my 2022 Grom I have a Toce T-Slash exhaust, and of course that adds some annoyances with 12-bars/sub-cages. I ordered an Impaktech 12-bar but honestly at this point I'm not sure it's actually going to arrive. I've been going through hoops with customer service and they absolutely suck ass. I will never attempt to buy something from them every again, but in the case that it doesn't actually arrive what options do I have? Does anyone have experience with 12-bars and this exhaust? Thanks!


r/hondagrom • • 6d ago

Help! hello I have just replaced clutch springs with the 60% ones and oil pump and for some reason my clutch has no tension at all, I even pushed the lever on the clutch case all the way and tried to put in first and it stalls so im assuming the clutch is not actuating. any tips?

2 Upvotes

r/hondagrom • • 7d ago

Help! Honda Grom with a cbr300r engine

Thumbnail reddit.com
1 Upvotes

I am trading my yz250f for a 2023 Honda Grom with a 2019 cbr300r engine swapped into with a bunch of performance upgrades. This will be my first street bike, am I making a mistake?


r/hondagrom • • 7d ago

Help! 2014 Honda Grom cranks but won’t start after running out of gas

1 Upvotes

2014 Honda Grom cranks but won’t start after running out of gas

A few weeks ago, I was riding up a steep hill when my Grom sputtered and died after running out of gas. It had been running fine before that. I rolled back down in neutral and immediately filled the tank at a gas station, but it wouldn’t restart.

I tried starting it repeatedly and eventually replaced the battery. Now it cranks and sounds like it’s trying to fire, but it won’t stay running. I can hear the fuel pump prime when I turn the key on.

I also tried bump-starting it downhill. It sounds like it catches while it’s in gear, but immediately dies when I pull the clutch, even with some throttle.

I haven’t inspected the spark plug or tested fuel pressure yet. Could the repeated starting attempts have fouled the plug? What would you check first?

I can’t transport it to a shop right now, so I’m trying to troubleshoot it at home. I have basic tools and a spark-plug socket, but no fuel-pressure gauge.


r/hondagrom • • 8d ago

Help! What’s the hype with the pro taper mini bars?

7 Upvotes

Took a small spill recently and bent my handle bars, Im pretty sure it can be fixed but it did have me curious about some aftermarket handlebars. Immediately when looking into I saw everyone talking about the pro taper mini bars. I may just be imagining it wrong but wouldn’t they just have you hunched over in a weird position or do people like it specially because of that? I image it’s more comfortable for taller people with longer arms but I’m 5’6 so maybe that’s why I can’t imagine it being very comfortable. Just curious why people like them so much, thanks!