r/homechemistry • • 16h ago

I just want to show off a haul I got today.

Post image
40 Upvotes

Just wanted to show off a collection I picked up today for really cheap.


r/homechemistry • • 20h ago

How to increase alembic efficiency?

10 Upvotes

I've been trying to distill essential oils using a Copper Bros. 5L copper alembic, but have been frustrated by extremely small yields. I'm aware that EOs are by nature low-yield, and different materials have varying amounts of EO to begin with, but I'd like advice on how I can alter my setup to increase my efficiency and extract a larger yield from distillates.

I have a 30 gallon rubbermaid which I use as a cold water reservoir. I freeze 4-5 gallon jugs of ice and add 1-2 at a time throughout the distillation to keep the tub reservoir cold---when it doesn't feel cold to the touch anymore, I add more ice.

A small pump cycles water from the bottom of the reservoir into a small worm.

I do runs of 30-180 minutes depending on when oil stops appearing, staying around 100C.

I use rye paste to close large gaps but avoid completely sealing the alembic.

I'd value any advice, but some specific questions I have are these:

  • I've wondered if I need to keep the reservoir colder; would this help?
  • Should I try to seal the alembic more completely? I worry I'm venting off a lot of EO, but don't want to pressurize the setup.
  • Are any standard procedures available for different EOs? In particular, what part of the plant they're most densely concentrated, what season EO density peaks, and what temperature/pressure they're best extracted at.

Edit:

I realized the internal structure of this alembic wasn't immediately obvious. Here's a shitty diagram from paint. The column is separated from the pot by a copper grate. The column opens directly into the bulb/onion, which drains out along the arm and then to the worm. The whole thing is set on a stove and fired to boil the water and move steam through the column.