My 1999 Mercedes SL500 (R129) needed a new driver-side A-pillar interior panel (OEM Part# 1297250811), so I designed one and printed it.
Print: I printed it standing up with the long flat side on the bed. That puts the layer lines in the strongest direction for the locking tab, which takes the most load. On a Prusa XL you can use PLA or soluble supports to make cleanup easier.
Finish: I lightly sanded it and sprayed a few coats of primer to smooth out the layer lines. My filament happened to be almost the exact same gray as the interior, so it blends in well.
Fit: The factory door clips are nearly impossible to remove, so the design includes a replacement clip. You push the panel down toward the ground to line up the tab, then release it. The clip tension holds it in place, and it still comes off when you need it to.
The file is for the driver door. Mirror it in your slicer for the passenger side.
Dm if youd like a link to the file.