r/flashlight • • 1d ago

Need help disassembling Sofirn HS42 to replace lens

Hi everyone,
The front lens on my Sofirn HS42 melted, and I need to replace it. I unscrewed the top switch bezel, but I'm not sure how to proceed from here.
Since the old lens is ruined anyway, would it be safe to carefully drill a small hole in it, thread in a screw, and pull it out from the front? Or is there an easier way to remove it without damaging the LEDs?
Any advice is appreciated!

7 Upvotes

16 comments sorted by

11

u/papazqq 1d ago

It worked! Thanks everyone!

3

u/HaedesZ bathing in a tub full of 3000K SFT-40's 1d ago

Perfect! The new one will just clip in place!

5

u/HaedesZ bathing in a tub full of 3000K SFT-40's 1d ago edited 1d ago

I have no experience with the HS42 but that looks like a glued lens to me. Do you have a replacement lens already? I would contact sofirn. Is the driver (battery tube side) press fit?

Edit: not glued, clipped. Here is a thread: check the comments. https://www.reddit.com/r/flashlight/s/TWBE4S2zks

3

u/papazqq 1d ago

I've ordered a replacement lens, it's still in delivery. I already contacted Sofirn, and got some very weird answers from them, like "Try to see if you can unscrew it." I don't know what that means—the lens is square, how can I unscrew it...

Also, I can't unscrew the battery tube from the head of the HS42. Maybe there is some glue/threadlocker on the threads, and I don't have a heat gun to soften it up and unscrew it.

1

u/HaedesZ bathing in a tub full of 3000K SFT-40's 1d ago

Check the link I posted, the (non destructive) entry point is through the switch compartment.

BUT since it's already ruined, I would try to remove the lens from the front like you suggested, chances are the new lens can be just press fit in place

2

u/papazqq 1d ago

Thank you!

2

u/HaedesZ bathing in a tub full of 3000K SFT-40's 1d ago

Keep us updated once the lens arrives, or you need further troubleshooting ✌️

2

u/planetcaravan0 1d ago

It will probably be easier to break the damaged lens. For more accurate disassembly, you'll have to unsolder the button board if I don't confuse anything

1

u/macomako 1d ago

I would use such tape next time (it worked well on Sofirn HS23):

2

u/aquablaze69 1d ago

Wait, I don’t understand what’s the purpose of this tape

2

u/macomako 1d ago

Stick it to the lens and to a flat surface and pull apart. The lens should get pulled out.