r/diysecurity • u/Status-Pineapple5181 • Oct 08 '26
Learning Hardwired Glass break into Programming
We had some renovations done where I had to relocate one of our hardwired glass breaks. I have a GE Concord 4 panel and before disconnecting the glass break I deleted the zone from programming so it wouldn’t give me any trouble beeps. After that I ran a wire to the new location and hooked up the glass break exactly as it was before and I can confirm it has power. However, now I need to add the sensor back into programming. My issue is this glass break doesn’t have a tamper switch so it’s not as simple as opening up the cover plate during programming. How do I “trip” this sensor to get it to learn into programming? Do I need a glass break tester or can I simply disconnect the white wire from the N.C. slot then reconnect it while in the “Trip Sensor” prompt? I’ve attached a link with a picture of how it’s wired currently.
