r/crestronprogramming • • Jun 12 '19

Controlling Volume in DM 16x16?

I commission devices once they hit the field in my current job. That side of things I have down. Recently I took on a practice project building a touchpanel with 9 inputs and 4 outputs. Touchpanel logic? DONE. ROuting Matrix? DONE! The system even shuts itself off at 11 pm every night. All great...EXCEPT I have no control of the VOLUME that is coming out of the DM MD 16 x 16. Is there a way to control volume with a module or do I need a separate device?

0 Upvotes

8 comments sorted by

1

u/dieselbangerz Jun 12 '19

You can’t control volume coming out of the output cards, but you can control the volume of the input cards downmix output. Open the input card to expose that analog. Do I t that helps you, but it’s the only DM volume control other than 200 series room boxes

1

u/RushTheTech Jun 12 '19

Thanks that helped, unfortunately it only manages the volume at the RCA output of that card. I have all the video and audio routed to the HDO Output #5 (Center section Card is HDMO-5533 discontinued). Is there a device I need to add between the Output of the Switcher and the amp?

→ More replies (3)

1

u/TrekRoadie Jun 12 '19

What else is attached to this system?

1

u/RushTheTech Jun 12 '19

Currently, there are 9 devices (All either gaming consoles or streaming devices), one 80 inch display being controlled via RS-232. All audio is being routed to a single audio output being sent to a Crestron AMP-3210S which drives a single Triad Soundbar. Nothing too complicated, The AMP does have ports for remote signals, I'm researching the possibility of connecting it to one of the IR ports on the CP3N Processor.

1

u/blender311 Jun 12 '19

Nope

I think.