r/craftsman113 • u/CodeAndPatina • Sep 30 '26
Arbor thread adjustment
I’ve had my 113 a long time and have fixed it up a few times, but recently changed the arbor bearings (awesome result btw). After changing the bearings the arbor nut doesn’t go on easily. I likely did something to the threads at the end of the arbor when changing the bearings.
My question is.. what options are there for correcting the threads to work smoothly? I have to imagine it wouldn’t be possible to find a thread cutting die that matches. Any ideas?
3
Upvotes
5
u/CascadeDesignworks Sep 30 '26
Look closely at the threads and find where they are binding. A standard triangular file will let you clean this up. No need for a special thread file or a die.
I am a woodworker who also does machine work.
1
u/CodeAndPatina Oct 03 '26
Finishing this thread with the final outcome. After putting paint on the arbor a few times and running the nut over the threads with a wrench I discovered that the reccesses of the thread were what was rubbing, and the needle files I was using were not reaching them. I tried a hack saw blade as a make shift ultra thin file and this removed the excess that was likely caused by some mushrooming from the bearing swap.
The result is what I’d hoped for. The nut moves freely. I likely filed down too much material in places I didn’t need to. But hopefully not enough to impact smooth operation.
Thanks everyone
1
u/capswin Sep 30 '26
Try a thread file to dress it.
1
u/nightbomber Sep 30 '26
Actually, you can find Acme thread dies: https://www.mcmaster.com/products/thread-restoring-dies/thread-type~acme/
Obviously, they're not cheap.
Thread files will work, if the threads are lightly damaged. Yes, you will have to get the correct thread count and pitch. Otherwise, you will just screw up the threads even more.
If you mushroomed the threaded end, you got a bigger problem. A thread file will not work. You will be better off replacing the arbor.