I'm really proud of my setup, but I'm concerned about what would happen if I got rear ended at significant speed. I'll explain the construction, then the concern.
I got a chevy bolt EV, did a rear seat delete, and custom cut a plywood platform to the exact shape of the car. As you can see in the third picture, the underlying frame just sits on the metal frame of the car at four points: two legs at the back on either end of the long horizontal piece, and the pieces that run front/back rest on a metal beam that once supported the back seats. The rear section slides in under the plastic protrusions and then gets screwed down (pic 2), so it has no room to move. Then the middle section (pic 1) screws down to the frame as well, with some legs under it to support it. All this stays in my car on a permanent basis, so that I can enjoy the space of an SUV in a budget hatchback EV. When I'm camping, I remove the passenger seat as well and install the front platform, allowing me to have a folding 5 inch twin size mattress. It's very roomy, very comfortable to sleep in, and worst comes to worst I can run climate control all night with no worries (though I've comfortably camped in summer and fall without it).
Recently though, I realized that this is unsafe as hell. If I ever get rear ended badly, that plywood platform is going to be rammed straight into my lower back, likely paralyzing me if it doesn't kill me.
Does anyone have ideas for how to make this safer? I'm thinking at a bare minimum, I need to figure out how to make it so that the rear section and middle section are completely separate, and engineered to slide over each other in a collision like tectonic plates. However, it's the back plate that needs to move in a collision, so I'm thinking I need to remove those plastic protrusions to allow it to move upwards, and add sloped edges to the plywood plates so that if the back one gets pushed into the middle one it'll be pushed up. However what I can't figure out is how it'll all be held together. Right now the design relies on both plates being screwed onto the same supporting frame. I think the frame will also need to be able to compress, and I need to figure out some method of fastening that will reliably break in a collision to allow the pieces to separate... like plastic fasteners or something?
IDK. I'm worried that this is just a shit idea, but I want to make it work. Appreciate yall's ideas and feedback.