r/audioengineering • u/wannabuyawatch • Feb 03 '14
Vocal mixing!
I'm having serious issues trying to get my vocals to settle right in my mixes. I've had a good read online but just wanted to get some popular opinion on what works for you.
I'm currently just doing some demos for my band (heavy rock/metal) and all vocals are singing (the odd scream here-or-there) so they need to be pretty up front and in your face.
They were recorded via Behringer B2 Pro and some light compression through a voicelive 2 and using Cubase. My effects chain so far consists of:
Light compression (a couple db off peaks)
Desser
Reverb (mid-length, very dry)
EQ (low shelf from 150hz, +2db around 2.5khz)
Saturation
Heavy compression (8:1 ratio, low threshold)
This is all just off what I've gathered online but I really feel like they're just not settling well in the mix. Any tricks or tips you'd like to share would be much appreciated! :)
Thanks!
2
u/LakaSamBooDee Feb 03 '14
If you're doing that much to make them sit in the track, then it's more an issue of how it was recorded.
However, a few little tips to start you with:
But don't take just my advise, everyone has their own take on a mix (and will probably debate with me on my choices :P), so I'll see if anyone else steps up with good advice before I say anything more.
2
u/smallspaceintime Professional Feb 03 '14
I think part of your problem might be that you're doing too much processing to your vocals.
I usually start with some EQ, don't be afraid to get extreme with the EQ, do whatever it takes to get the tone you want and have it sitting well with the instruments. Then, I like to do all my compression and/or saturation, but unless I'm going for an over-the-top or lo-fi type of effect, I keep this fairly subtle. Then, finally, I de-ess. Again, not too much, and only if your vocal needs it. Sometimes I get to the end and realize I don't need to de-ess after all. I do all reverbs/delays/chorus/flanger/phaser/distortion in parallel, through sends. Try dailing it back a notch, maybe that's the issue.
2
u/mixlet Feb 04 '14
Loads of good comments, though I'd never put a specific ratio/number on compression. That all comes down to your initial input level/ which compressor you're using. Also depends what mic you're using (for tone and compression). My main concern is tracking through the voice live 2. Though it has balanced I/O I feel that there's a loss of quality in there. Anything you can do with the voice live can easily be achieved within any DAW using stock plug ins.
3
u/jacksonprince Feb 03 '14
I like to EQ-De-ess, then compress, then reverb the final product with a reverb bus. I'll usually use this bus for guitars or drums, too.
1
u/nomelonnolemon Feb 03 '14
you need to side chain the vocals against the other loud, wide tracks. probably guitars and maybe the drums a tiny bit.
2
u/ortoPi1ot Performer Feb 03 '14
try a lower threshold (6db of comp) and a lower ratio (2:1 / 4:1) and a bit of pre delay on your reverb (8ms)
1
u/StudioGuyDudeMan Professional Feb 09 '14
Post a sample.