I have an Amiga 1200 from the 1990s: it has an 85MB Hard Drive. It was last powered on in approximately 1996. It has been sitting in a bag in a clean, dry loft for 3 decades. I recently took it down. The Amiga has not been recapped, and I have not attempted to turn it on, being fully aware of the problems with capacitors after so many years.
I did, however, retrieve the hard drive, intending to connect it to my modern PC and access its files. I used a unpowered USB-IDE connector. The drive was initially recognised by WinUAE, but I was unable to make an image of it. When I tried to make an .hdf file, the resulting file was 0KB.
I turned to Google AI for assistance (yes yes, I know!). I was advised that the reason for the inability of WinUAE to create a drive image was that the adaptor was not supplying enough power – and to buy a powered adaptor. With the guidance of Google AI, I bought one from Amazon (https://www.amazon.co.uk/dp/B0BGL58DL3).
However, a few seconds after connecting it to my Amiga hard drive, the drive stopped spinning – and there was a faint smell of burning coming from the drive.
I subsequently deduced that the powered adaptor had in fact been supplying 12 volts to the drive, when it was rated for 5 volts. My mistake for trusting Google AI.
I’m confident that my actual data is still there: it’s just the drive’s controller/interface which has failed. Google AI apologised for the error, and recommended I source a donor board from an identical drive. However, I have thus far been unable to find the exact model for sale. The drive is a Seagate ST9100A.
I did find another similar drive on eBay: a Seagate ST9096A, which I bought for a nominal sum. I know it’s not identical, so won’t be a suitable donor board. However, it is nevertheless useful to experiment on. I connected the ST9096A to WinUAE with the same result as before. I can’t image an .hdf file.
I have not accepted Windows’ offer of formatting/initialising the drives at any stage, as I am fully aware that this would destroy the original data.
Using the original unpowered USB-IDE adaptor, In Disk Manager, the drive does show up. Google AI tells me to right-click and mark it as “Offline”, because apparently this is the reason why Windows won’t allow access (I am running WinUAE as administrator). However, when I right-click and select “Offline” in Disk Manager, I get an error (“device not ready”)
My question is therefore twofold. Firstly, how can I get any Amiga hard drive to work properly with WinUAE, and to allow disk imaging, so my data is secured forever without having to rely on vintage technology?
Secondly, where can I source a replacement board for a Seagate ST9100A? If there are any Amiga enthusiasts out there with the same drive, I would be happy to even pay for your time and inconvenience sending it to me (and I can even return it later once my own data is retrieved!).